After the spin cycle the water is still dripping out if the cloths. What may be the problem?
You will want to check the pump to make sure that there is not anything that is clogged or obstructing proper drainage. Also make sure that you are not overloading as this would also cause the issue.
Washer goes thru cycle OK. While this is going on, water keeps running into the tub. The tub overfills and spills over. I can shut the water off and restart the mashine. This works for a short time. Then the same thing happens. How do I fix it?
Answer Hello Carey. If you can stop the water from entering the machine by turning off the timer or unplugging the unit, you will need to look for a bad pressure hose or replace the pressure switch. If the only way to shut off the water is at the shut off for the water hoses, you will need to replace the water valve in the unit.
Water will not drain. You can hear the pump motor humming.
Answer Hello Red. You need to make sure there are no clogs. If not, you will need to order and replace the pump on the unit.
spin cycle not working
To properly assist you we will need your model number to help you with this. Please post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx
I have a GE model # WBB2090F1WW. The washer agitated fine but most time will not start the spinning circle but still drained the water. Any help on what to do and parts # to replace will be appreciated.
When the unit is supposed to go into the spin cycle you would want to check for power to the motor to make sure that the timer is sending power to the motor. If you do not have 120 vac to the motor then either the timer is faulty or the wiring but would most likely be the timer. If there is power to the motor but it is not running then you would need to check the windings to make sure that they are not bad and check to see if the brake is releasing in transmission. If the brake does not release then the unit will not spin.
My washer was overloaded and then spun out of control. Then it just stopped. It will not reset or start a new cycle. All the lights will turn on, but the washer will not do anything. I have tried to reset the motor by unplugging it and closing and opening lid six times, this is not working. Also the motor is flashing in one second intervals. PLEASE HELP!
You will want to check voltage on the inverter board of the motor for 120 vac. If you do not have 120 vac then the in line fuse in the wiring harness is bad and will have to be replaced. You need to check Connector C2 pins 3 and 5. IF there is no voltage then follow white/red wire up from pin 3 and you will find the thermal fuse approximately 1/2 way up tub in the harness. You will have to cut out and replace the fuse WH49X10055.
I have a ge washer model wjsr4160d5ww. At the end of the cycle it does not completly empty. This is at the rinse cycle nothing clogged anywhere. It just seems that the pump does not run at that part of the cycle.
Answer Hello Anthony,
You will want to check the pump for obstructions but also you want to check the vanes of the impeller to make sure that they are not damaged. If there are damaged vanes it would cause unit to not drain properly. If this is the case then you would want to replace pump.