24/7 Customer Support

CHECKOUT
Items in Cart:
Total
$0.00

Customer Questions and Answers for Transmission and Brake Assembly by GE

  1. Our Price $145.72
    Compare At $324.63
    You Save $178.91
     Watch Video
    • Part Number: AP2046402
    • MFG Part Number: WH38X10002
    • Made by: GE
    Add to Cart

Questions & Answers

For GE Transmission and Brake Assembly (Part Number: AP2046402)

Ask a Question

Most Interesting  |  Latest Questions

How do you change out a transmission and brake assembly on a ge profile washer?

Don

Answer

2 people found this answer helpful.

Was this helpful?

1 Answer

Would the tub spinning instead of the agitator indicate a failing transmission? GE Profile top-load washer.

Dab

Answer

1 person found this answer helpful.

Was this helpful?

1 Answer

I have a ge modle s4200b2ww that the transmission / brake assembly AP2046402 unit started to leak greese/ oil into the washer. Is there a seal/berring kit to fix this unit or do i need to buy a new transmission/brake assembly?

Scott

Answer

1 person found this answer helpful.

Was this helpful?

1 Answer

GE unit is uncharacteristicly loud as it works through spin/rinse cycles. What could be the possible causes?

Gary for Model Number WCRE627DOCC

Answer

Was this helpful?

1 Answer

I have a Hotpoint washer it. Will do everything: spin, drain, everything except it will not wash. May this be the transmission?

Stephen for Model Number VBXR109OD8WW

Answer

Was this helpful?

1 Answer

Hi I have an older washer and now it appears that there is grease/oil coming out under the agitator. any Idea where that may be coming from? Seal from transmission leaking perhaps? Thanks

Rein for Model Number GE WLSE 3150

Answer

Was this helpful?

1 Answer

Do you sell the seal for the bushing on transmission?

Tammy for Model Number gg177698g

Answer

Was this helpful?

1 Answer

I replaced the tub bearing yesterday, everything seems fine, except the spin cycle is much louder than before. I didn't use any grease. Is there a break in period on the new bearing, will it quiet down over time? Do I need to use some sort of grease on the new bearing? Thank you

Eric W for Model Number WWRE5240D1WW

Answer

Was this helpful?

1 Answer

My trans shaft is pitted. Will this cause leak at tub seal?

Ken for Model Number WJSR2070B2WW

Answer

Was this helpful?

1 Answer

10 year old washer won't spin with medium to large load size. Motor hums and smells after a couple minutes. I open the lid, spin the drum counter clockwise, close the lid and it will spin. When spinning by hand or if the motor spins the drum while loaded, it makes a loud clunking noise. With the front cover off the spinning parts underneath seem out of balance. When the washer is empty and "spin only" is selected, it starts and stops just fine with not nearly as much noise. Water looks to be dripping from transmission bearing area. The floor under the unit is pretty wet and dirty. Thx for the help, great site.

Kevin for Model Number WCSE6270B2WW - GE Washer

Answer

Was this helpful?

1 Answer

 

 
 
We are Safe, Secure, Dependable and Trusted
  • BizRate.com Customer Certified Site - Click to Verify