I'm trying to remove and replace the recess trim around the ice dispenser. I guess if you can list step by step the procedure in doing this I would appreciate it. It appears in my model the trim is screwed in at least on both sides. I cannot seem to be able to remove the interface section that displays the 3 different modes I can select. Thanks Steve
Answer Steve, Here's the information you'll need. The door dispenser control panel allows the consumer to select water, crushed ice, or ice cubes. It is an interface to the main control board. 1. Use a screwdriver to unlock the tabs at the bottom of the control panel. Slide the bottom
out and down. 2. Disconnect the wiring harness connectors. Note: Inner door panel must be removed to remove recess trim. So you'll need to remove the freezer door inner liner to access the trim screws inside the door.
Using a putty knife isn't getting me anywhere removing the faceplace. It seems to be screwed in.
Answer Hello Paul. Door Dispenser Control Panel
The door dispenser control panel allows the
consumer to select water, crushed ice, or ice
cubes. It is an interface to the main control board. 1. Use a screwdriver to unlock the tabs at the
bottom of the control panel. Slide the bottom
out and down.
2. Disconnect the wiring harness connectors.
Note: Inner door panel must be removed to
remove recess trim. Then you can access and remove the screws holding the outer trim on.
I ordered the trim replacement part for the ice and water dispenser. I have had to remove it in pieces. It would not pull off and unsnap the snapping parts broke off and I dont know how to get them out to replace with the new trim.... drill out the plastic pieces ???? they cant be pushed thru help!!!!!!!!!!!!!!!!
Answer Patience, Hopefully, nothing is damaged, but heres how to remove the trim "The dispenser assembly consists of the interface, display board, dispenser shield, and duct door functioning parts. The dispenser interface can be removed to access the display board and the
dispenser shield mounting screws. The interface is held in place by 4 tabs that hold it to the dispenser recess. To remove the interface, it is necessary to grasp the bottom lip of the interface on either side and gently pull it towards you. There are 3 wire harnesses connected to the display board. Note: The interface and display board are replaced as a complete assembly. When assembling, insert top tabs into the top of dispenser recess fi rst, then snap the bottom into place."
I want to replace the cracked trim piece around the ice and water dispenser on my Hotpoint model #HSS251FMD refrigerator. How do I remove the old trim piece? Do I just snap it off from the outside?
Answer Hi I&I. Yes, you will need to put masking tape around the fountian control trim piece. Then you will either use a small putty knife or a small thin blade screwdriver to pop out the rear clips holding it on. The trim piece is part # WR38X10204. Thank you.
The freezer door flapper will not close completely.
Answer Hello Robert. You will need to check and see if the solenoid assembly WR62X10055 is bad and is sticking on the unit. If so, you will need to replace the solenoid. Hope this helps.