Just need the inner door glass just broke no reason. Need part # please
The door glass cannot be purchased separately and you would need to get the complete door assembly 3581ER1008V.
The glass broke on the door of this washer, just need the glass, not the whole door. What is the part number?
Answer Hello Cindy, this door assembly 3581ER1008T is the only way the manufacturer supplies the door. You cannot get just the glass. Usually this is because of the assembly process. The way it's put together at the factory may not make it possible for the individual to get it back together properly without a machine or special tools. Thanks!
My inner door is cracked, it has been for a while. I recently experienced a large leak, came home to a laundry room floor full of water. Could this be anything other than a complete door assembly? Does the door assembly come as one piece that I can change out, or is it many pieces that I will have to assemble?
Answer Hi. Yes the inner door crack will allow the leak if the door boot seal part # 3581ER1008A does not seal against the door perfectly. It will leave water traces for show if this is where the leak is from. If you have a lower cover door for the pump, then make sure the pump is not clogged. Release the tubing on the back side of the cover into a bucket. Once all water is drained then you remove the pump cover and clean the catch and pump impeller area so it drains correctly. If the pump impeller is loose on the shaft then replace the pump part # 4681EA2001T. Thank you.
The washer is leaking on the rinse cycle. Also the inner glass on the door is cracked. What part is just the inner glass on the door? Is there a gasket that needs replaced also on the door?
Answer Hi. The whole door assy. part # 3581ER1008A is the only way you can replace the inner door cover crack. Remove the back panel and see if the drain hose part # 5215ER2002G has a pinhole leak. Look at the door boot part # 4986ER0004F inside and at the 6:00 position to see if it has a rip in it as well. Thank You.
I wanted to know my glass is crack to my washer door. I was ordering the door I need to know when I order the door assembly, does the door come with the glass ? I need to know if I need anything else. When I close the door my door don't click so the water won't come in to wash the clothes. Is the sensor on the door when I replace it or do I have to order something else along with the door that I will be ordering ? Thank you, waiting for your response.
Answer Hi Linda. Yes according to the view, the door assy. comes with the glass assy. part # 3581ER1008A. If the door does not click, is the door striker allowing the door latch to know it is closed ? If the door strike part # MFG62439301 does not enter the door latch part # 6601ER1004C fully it will not allow the signal to return back to the main control board part # 6871ER1078T. Since the board does not "see" a shut door latch, then for safety reasons it will not allow fill. Look carefully at all of this as you are trying to close the door. You may simply need the door hinge assy. part # 4775ER2002A to stop the door from sagging to allow the proper fill. Thank You.