How do you lift off the glass top of the stove in order to replace a burner that is not working?
Answer Hello c killion. Open the door and remove the screws under the front edge of the cooktop. Now you can lift the top on the unit.
How do you undo the wiring clip that goes to the burners when replacing the glass cooktop?
The wire harness for the top surface elements should just have a gang plug that you disconnect. Once disconnected you can remove the burners and replace the top.
I need the glass top for my LG electric range. Does the glass come with the frame or just the glass alone? And does it come with instructions? Thanks.
Answer Hello Peter! The glass top listed for your model is part number AGU73969703. This includes the glass and frame. Unfortunately, the manufacturer does not provide the installation instructions with this item. If you need assistance, please let us know. Thanks!
I need a ceramic glass top replacement. Where do I get one? Thank you.
Answer Carol, the cooktop replacement listed for your model is part number AGU70894502. Thanks!
Is part numberAP4438153 the right part for my stove door glass? It is a black glass.
Answer Hello Dale! Yes, glass part number 4890W1N005A is the correct inner most glass of the oven door. However, the outer door glass is part number MKC47970112. Thanks.
Is this easy to install the gas on the stove?
Does the glass comes with instruction to install?
Answer Hello Celeste. The cook-top 4890W1N005A comes with the frame and glass. Unplug the cord or disconnect power. Open oven door and
remove the 3 screws located
at the front of the cook-top,
then close the door. Lift up the cooktop front and
Remove the ground screw
securing ground wire. Slightly lift up and pull up the
cook-top and then unplug
the 2 connectors at the back
by squeezing side tabs. Protect the cooktop surface
and turn the assembly over. To remove the surface elements
a) Remove the wires from
the element and limiter
b) Remove the element
bracket screw (shown
above) for the element
you are servicing.
d) Carefully lift the bottom of the bracket just far enough
to remove the element.
REASSEMBLY NOTE: When you reinstall the element
make sure that the wires are inserted into the correct
tap then reinstall the bracket screw to secure it to the