I am looking for the removal and installation instructions for the right door Gasket holder assembly part # 4931J2002A.
Answer Hello Hugh,
To remove the right door holder assembly, you would first remove the cover that extends the length of the door. Just pull from the bottom and it should release its clips. When you get this off then you will remove the top part of door seal. It just pulls out from door. When you lift the edge of the door seal on the side of the door you will use a flat blade screw driver to pop the holder assembly clips loose. There is an upper and lower to release. You can then slide the old holder off the gasket and install the new one. Reassemble in reverse. Keep in mind that on the top clip that clips into the door there is a spring that has to be pushed inward before you push the clip in.
Installation instructions on removal of assembly gasket and reinstallation.
Answer Hello Hugh. We will need your model number to help you with this. Please post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx
My Cam, Shaft right (part 234A on your diagram) came off. It appears that the piece it attached to cracked. Does Holder Assm.,gasket (part AP4439768) attach to part 234A (by wrapping around the screw at the end of 234A? If yes, how easy is it for me to take out and replace the Holder Assm.,gasket (part AP4439768) once I purchase it? Thanks.
Answer Hi Steve. All most unfortunate. Were the doors removed during installation? Yes all of these parts will be readily replaceable while the doors are off. Then it is always a good added measure to use a dab of white lithium grease on the pivot points before reassembly. !st- remove the upper door hinge cover on one side. Then disconnect the elect. connectors (if applicable). Then remove the top door hinge. Then lift up the door assy. up and off the unit. Then you have access to the complete lower door stopper's part # 4620JJ3006F and part # MJB63029901. The cam shaft rt is part # 4430JJ2004A. The cam shaft lt. is part # 4430JJ2004B. Thank You
Is this the piece to which the hinge cam attaches?
Answer Hello Ray. No, that is the gasket holder. The cam shaft part number is 4430JJ2004B for the left and 4430JJ2004A for the right. Hope this helps.