I have the same situation as the person above. I ordered the new ice funnel and the new replacement part due to design change. My question is, how do I remove the front panel to replace the whole new assembly? I would appreciate you help.
Answer Hi Wesely. DISPENSER. 1) Disconnect funnel and button assembly by pulling down and forward.2) Remove display frame Assembly by making a gap between a display frame Assembly and funnel Assembly. with a balde screwdriver and pulling it forward. The cover dispenser is attached with a hook. 3) The Display Assembly can be connected by pressing the top of the dispenser cover and pushing it after separating the Display Frame from its housing. 4) Loosen four screws with a phillips screwdriver and pull the funnel Assembly to disconnect. 5) The Duct Cap Assembly can be disconnected if the hold lever connecting screw is loosened with a phillips driver. 6) To install the Duct Cap Assembly, insert one end of the spring into the right hole of the dispenser lever and insert the other end into the right hole in the top part of the dispenser. Then attach the holder at the solenoid switch. Thank You.