Ice machine will not fill with water but dumpimg arm works.
Answer Hello Ken,
I would check to see if the fill tube is frozen. With a frozen fill tube the icemaker will cycle but not put water into icemaker. If the fill tube checks ok then you will want to test the water valve to make sure it is getting 120vac when the icemaker calls for water. If you are getting 120 vac but not getting water then you need to replace water valve. If you are not getting 120 vac then you need to check your icemaker to ensure you the icemaker is sending 120vac to the water valve. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html
Have a LG ice maker very similar to the one shown. The ice maker makes a clicking noise and it appears to be the ejector arm is stuck and not moving. What can be done to fix the ejector arm?
Answer Hello Craig,
LG has never made any repair parts available to repair their ice makers. The only thing you can do is replace the ice maker assembly. I would have listed a part number, but I cannot look up a part with out a valid model number. If you would like us to look the part number for you, you can re-post or you can call in and one of our operators will be happy to assist you.
Bought LG LSC27950ST 3+ years, now the ice maker will not make ice. Ice jammed in bucket, unloaded ice and cleared out drop spout and now ice maker will not make any ice. I/O switch cycled, water level switch cycled (green light rotates)-no water is heard, no ice in tray and no ice is made. Metal level arm is out at 3-oclock position and does not move. Any recommendations before ordering and replacing the ice maker? Thanks.
Answer Hello Alan,
The L.G. is an unusual animal in the sense that nothing at all can be done to the ice maker. No parts are available, no specifications are available, and no factory support. I don't think the good folks at L.G. even know how to fix one. All that can be done is to replace it as an assembly. Anytime cycling the ice maker doesn't energize the water inlet valve, the ice maker has to be replaced. Especially with the bale arm at the three o'clock position, my estimation is that, regardless of whether the water valve is good or bad, the ice maker is in need of replacement.
I was getting an ER IF code until I reset the pcb board and now the ice maker is flashing and no water is dispensing and the interior lights are not on. I can hear the fan motor coming on and off and the front panel clicking at the same time, although the freezer and refrigerator appear to be fine.
Answer Hello Gene,
This sounds to me like a power supply issue. The PWB EBR34917110 is probably the issue. The reason for this conclusion is the fact that the clicking and the fan motor is in sync. The fan 5209JA1044A for the ice maker is the issue that caused the ER IF code so it could either be blocked by ice or it could have just failed, causing the PWB failure.