Hi I need 25' of this... How much for product and how much for shipping and postage? Thank you
The part number listed 5210JA3004K is not a 25' section and does not come as such. Here is a part number for a Frigidaire water tank kit which has 5/16" water line coiled up. Not sure how much it is that is coiled up but will be as close to 25 foot as you can get. The part number for this tank is 5303918258 and has a bigger thickness of the outer wall then the other part.
The water line running from the bottom of the freezer door to the dispenser is leaking. How can I replace this and with which part? Thanks
Answer Hello John,
I'm sorry but the water line is not listed individually. This normally means that the water line is installed in the blown insulation at the factory and is not considered serviceable. To correct the issue, the door assembly 3581JA8569B would have to be ordered.
Is this tube the same as yours if not could you please let me know the length many thanks
If we have the model number of the refrigerator we can confirm the part number for the tubing that is needed. Based on the part number supplied 5210JA3004K this is a LG tube for a refrigerator and is 5/16" O.D. We do not have the inner dimensions for the tube. The length of the tube would be approximately 6 ft long.
How do you replace a water tubing from the water dispenser goes down the door of a LG side by side Ref.
Answer Hello Marcelino. We will need your model number to help you with this. Please call 1-877-477-7278 or post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx
One of the two tubes going up to the filter on the back of the fridge cracked about 2 inches from filter. Can this be replaced or fixed?
Yes, The tubing from the filter to the water valve can be replaced on your unit. You would want to order part number 5210JA3005E. To replace this tubing you will need to pull the unit out and shut off the water. Remove the lower cover of the compressor compartment. Once removed then remove the water valve. Where the tubing goes into the valve there will be a color ring around it. inbetween the valve and this ring is a clip that needs to be pulled out and then you push in on the color ring and pull out on the tubing that needs to be replaced. You then remove the cover and clips that hold the tubing in place going up the rear wall of the unit. It may be best to remove both tubes from the valve. Once this is done then open the refrigerator door and remove the top shelf. Remove the light cover and there will be a couple of screws holding that complete assembly in place. Remove the screws and pull out the ducting assembly. This will give access to the water filter head which is held in by 1 or 2 screws.