Evaporator motor won't run I pull cover in freezer do I suppose get ohm reading from all three wires.
Answer Samsung Refrig side by side,
You will want to do a voltage test at the main control board to make sure that there is power leaving the control board to the fan. You will want to check on the CN75 connector to do test. You will go to whichever fan pin that is not working to the ground which is pin 10 and check for 7 to 11 vdc. If no power then replace the control board and if there is power then replace the fan motor.
I have a Samsung refrigerator. The compressor wont start. I hear a ticking sound every minute or so but it wont start. Thanks!
Answer Hello Francisco,
This sounds like you may have a bad start relay DA35-10013Q on the compressor. If changing it corrects the issue, you are good to go. Unfortunately, if it doesn't, you could have a bad compressor. There is a slight possibility of a bad control board, but this isn't likely, given the complaint details.
I want to buy pipe (wire) that connects the dryer with vent.
Answer Hello Qazim. TJ74X5ULC is the 5ft. dryer vent pipe and TJ78X4R is an 8ft. dryer vent pipe. Hope this helps.
My refrigerator's walls are extremely hot although the freezer and refrigerator still seems cool. I unpluged the power. I know other people had same problems. What parts seem need to be replaced? How to replace compresser parts?
Answer Hello. Based on the information you provided, it sounds like the condenser fan motor DA31-00103A may be bad. Check and make sure the condenser coils are clean, and the fan motor is running properly. If the motor is running slow, or not at all, you will need to replace the fan motor. Make sure there is voltage coming to the fan motor if it is not running. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps.http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html
What would keep the compressor from coming on? If I fiddle with it (unplug etc) it will come on and cool... otherwise it will not. The control board will show the temperature coming down however! Thanks!
Answer Hello Gayla. The PBA board is what powers the compressor. If the board is bad, you can get false readings on the sensors and the compressor will not come on. When you unplug the unit, you reset the board and cause the compressor to come on. It sounds like the board may be your problem. Hope this helps.
What causes your ref to freeze up?
Answer Hello! Your refrigerator seems to have a defrost issue if it is freezing. The defrost is made up of three parts; defrost themostat, defrost timer, and defrost heater. Hope this helps!