Is any touch up paint safe to use in a microwave?
Answer Hello Roland! No, you can not use just any type of touch up paint. It'll need to be microwave interior touch up paint. For a pearl white touch up use part number TJ98QBP0301 and for a citrine white use part number 261869. Thanks!
Would you send a repair person out to do the actual touch up??
Answer Hello Diane. AppliancePartsPros.com is a company who assist DoItYourselvers repair their own appliances. We do not offer service repair at this time. We can suggest researching through your dealer or the yellow pages.
Hi: The bottom of my white bathtub has a chip that is about the size of a nickle. It has a little bit of rust on it. Can I use your product in the bathtub, or do I need a rustolium product? Many thanks, Mary
Answer Mary, Yes, you could use a basic white enamel touch up paint to cover the chip in the tub. But, first you need to remove the rust and roughen up the surrounding area with sand paper. This is only a temporary repair, and will need to be touched up again, and again,etc.
The door handle is starting to discolor. Can I replace it or paint it?
Answer Hello David! Yes, you should be able to paint an appliance door handle using appliance spray or touch up paint. Thanks!
My Kenmore side by side freezer, ref. is not freezing and I hear the compressor click click click once i n a while. cleaned the coils on bottom but no improvement. Compressor is so hot you cant lay your hand on it but you can touch it. Is that normal operation
Answer Arion, The "click" noise and the cooling issue is most likely due to a weak or faulty start relay and overload 2262185 , 2183456. You also want to check and make sure the condenser fan motor is running properly, and you have removed all the lint, dust and debris, in the compressor compartment and surrounding area. Yes, the compressor can and does get "hot" to the touch, this is normal, but improper air flow and a weak voltage or relay, can cause the compressor to overheat.