What is the cu capacity of a whirlpool topload washer model # LSQ9645KQ1?
Answer Hello, this unit is listed as a 3.2 cu unit. Hope this helps.
1 person found this answer helpful.
When I run the washer, the basket doesn't spin but I heard that the machine below the tub was spinning. The first time that this thing happened, I could smell like electric burn too. Also when the machine was running from wash to rinse to spin to done, the lid locked light was off. Below I wrote down the time that each thing had happened: Put two small piecies of kitchen rugs into the washer,
8:27 a.m. Sensing was on, lid locked was on, in a few second lid locked light was off then was on again.
8:37 running water, Lid locked was off, and sensing light was on.
8:47 stop running water, change to wash cycle, but the machine was quiet.l
8:52 drained water out, the machine was spinning but not the tub.
8:56 running water
8:57 changed to rinse cycle, had some water in and drained
8:58 changed to spin cycle, quiet until 9:18 a.m.
9:18 Spinning only at the bottom not the tub
9:22 changed to Done and the rugs are still soak wet.
What is the problem? Can I fix it myself, what is the part and how much? Thanks.
Answer Hello Nuttaya,
This unit needs to be put into the self diagnostic routine. This is fully explained on the tech sheet, (in the control panel or in a plastic bag inside the front of the main cabinet). It is initiated by pressing "SOAK - SOIL LEVEL - SOAK - SOIL LEVEL" within five (5) seconds while the machine is in Standby Mode. This will pull any fault codes which will lead you to the part of the unit experiencing failure.
What is the capacity of this model?
Answer Hello John! Your model is a 2.50 cu ft extra large capacity washer. Thanks!
I had a leaky valve, I replaced it works fine, but now when I fill it up it does not agitate, it only drains.
Answer Hello Jeff,
Check that the standpipe is still at least the height of the main top of the machine so the unit will not siphon the water out as it is filling. Then you will need to check the pressure switch 3356467 since the unit will not agitate until it has been satisfied.
Water is coming out of the front door when it is spinning.
Answer Hello Bill,
Front load unit are designed so they will not spin with water still in the unit. The pressure switch and the door boot should both be checked closely.
Washer wont start.
Answer Hello Karen. If there is power coming tothe control board, but not out of it, replace the board on the unit.