The burners on this range are very rusted/corroded. How do I change them?
Answer Don, the burners like this one 3403M075-10 just twist off but you have to be careful not to break the ignitor as you do it. Hope this helps!
This range is fitted for propane, but the temperature of the flames has always been low - boiling water takes forever. Is there any way to increase it?
Answer Hello, here is a link to the conversion process https://www.whirlpool.com/digitalassets/MLPDF/Installation%20Instructions%20-%208101P534-60.pdf . Make sure the conversion was performed properly, however when this unit runs on L.P it will bring down the ratings of the burners to 7,500-9,000 btu's. Thanks!
The unit has been LP converted. It has always been slow to boil water. It seems like it isn't not hot enough for Wok. Ideas?
Answer Hello Don,
Have the gas valves under the knobs been adjusted? The flame on low should be adjusted to just rise above the burner cap.