I need instructions on how to install part 3374716 channel retainer that I just purchased.
Based on your unit model number. It is not showing a channel retainer for your unit.
Is this the part that will stop the leaking from under the door?
Answer Hello Sandra,
This part can help in some cases but, most of the time a spray arm is separating, holes in the spray arm are stopped up, or the unit has been over soaped. Of course you can inspect the spray arms for food particles and separations, but to check for an over soap condition, you have to start a cycle with no soap and no dishes. Let it fill with water and circulate the water for 1 to 2 minutes. Open the door and wait 20 seconds. Now after 20 seconds any bubbles present will be soap bubbles. If this is the case, the situation can be cleared with a sanitation cycle.
How to reverse the front panel from white to black ?
Answer Bill, Here's the information you 're interested in. "To change door panel color NOTE: The opposite side of the door color panel is a different color. 1 Insert fingerunder one end-of retainer and pull towards you in a peeling action. Set retainer aside. 2. Lift door panels at outer edges. Use one hand to bow bottom of panel. Remove panel(s). Do Not remove spacer. 3. Insert one side of door(s),with desired color facing out,into one sideof the door frame. 4. Bow door panel(s) and insert otherside of door panel(s) into door frame. 5 Push in on door
panel(s) near the top and slide panel(s) and spacer up inside bottom of control console, allowing panel(s) to rest on channel at bottom
of door. 6 Snap one end of retainer into W channel as shown. Push inward while sliding thumb along full length of retainer. 7 Check door for proper operation. Door should close easily without slamming and open with its own weight. If necessary, close door and adjust both door springs by moving spring ends to different hoes in base. 8 Push up with thumbs on each end of access panel top trim to unsnap trim.
Remove top trim and set it aside.9 Carefully slide color access panel and spacer upwards and remove.Do Not remove spacer. 10. With
desired color facing out, bow access panel and insert into access panel frame.Slide panel down ino groove along bottom of access panel frame. 11. Line up edges of top trim with sides of access panel frame. Tilt back of trim down and slide into place. Snap front of trim down to cover top edge of access panel." Good Luck and Thanks
Is this the piece that goes across the bottom of the colored door panel and holds it in place? Damn dogs chewed the other one off.
Answer Damn Dogs, Based on your post description you're needing two parts: the retainer strip 3374011 and the retainer channel 3374716 to repair the door trim properly. Thanks and Good Luck