My 4 years old kitchen aid refrigerator the freezer compartment building up ice and the icemaker do not making ice. Please advise. Thank you.
Answer Hello Ken. If the coils inside the freezer are frosting over, It sounds like you may have a defrost problem with the unit. Check and see if there is any frost build up on the evaporator coils in the freezer. If so, you will need to test the defrost heater and the defrost thermostat. They should read closed for continuity when cold. You can test this with a multi-meter TJMA-DMT3. I will include a link at the end to assist you how to use the multi-meter if needed. If both parts are good, you will need to replace the defrost timer. Once the problem is repaired, you will need to thaw out the ice on the coils before the unit will operate properly. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html
I have a Kitchenaid refrigerator, model (kscs25inss01). I need the control board ap4411082. Thank you
Answer Hello Edgardo,
I'm sorry but this part has been discontinued by the manufacturer and no satisfactory substitutions have been provided. The only thing we can recommend is to contact corecentricsolutions.com and see if they support this board. If they do, they can refurbish it for you.
So were is the main control board no. w10219463 located at? up at the control panel up on the fridge inside the main control box or behind the fridge? Can you tell me how the fridge control panel is is disassembled? I see only 2 screws, the ones that hold the light assembly. THis is for a whirlpool GC5SHEXNS00. Thanks..
Answer Cesar, The main control board W10219463 is located on the back of the refrigerator. You will need to move the refrigerator out away from the wall and remove the lower compressor compartment cover. You will find the control box and cover located to the left of the compressor, near the left cabinet side wall, so you'll want to make sure you disconnect the power cord from the outlet and turn off the water supply to the water dispenser and ice maker, before you dismantle anything.
I need to replace my control board. I was told the part number is W10219463. I am unable to find this or a suitable replacement. Please advise.
Answer Jeff, I've found model KBLS36FMX01. Electronic control W10219463 is the correct replacement listed for your appliance. Unfortunately, this item has been discontinued with no further replacements or cross references available and our company is unaware of any other available sources. Sorry about that!
My compressor fan keeps running then stops for a second or two then it starts again. Everything else works perfect. What can i do to resolve this problem?
You will want to do a voltage test on the condenser fan motor to determine if there is constant power to the fan and to ensure of no voltage drop. If there is no drop of 120 vac plus or minus 10 percent then the motor is faulty and would need to be replaced. If there is voltage drop then the electronic control is faulty and would need to replace the control board.