My display went dark but some keypad buttons still beeped. I got the control board from you today and now display works. I get F5 E1 message, followed by E1 F5. Then after a while only F5 stays on the display. I can set the clock but when I hit start it goes back to the F5 display. I'm guessing now you will say I need the keypad. That is a crappy connector for the ribbon connector by the way - I have played with it but no improvement.
Answer Hello Phil,
The F5 E1 fault code is the code indicating the Self-clean latch will not lock/unlock. The tech sheet states the following on this issue: 1. Check the latch assembly: latch arm pivot joint, arm/motor connection, plunger and hook springs. 2. Check the Latch Motor: - Check for firm electrical connections. - Disconnect the two wires from the motor and measure the resistance of the motor. The resistance should be approx. 2450O. If the motor is open (8O) or shorted (0O), it should be replaced. 3. Check the Latch Switch. Disconnect it and use a continuity tester: - Door latched = switch closed, continuity should read 0O. - Door unlatched = switch open, continuity should read 8O.
4. Check Door Open/Closed Switch. Disconnect it and use a continuity tester: - Door open = switch open, continuity should read 8O.
- Door closed = switch closed, continuity should read 0O. 5. Check Sister Board. - Check connections, latch motor – sister board. - Replace sister board. 6. Check power and element connections. 7. Replace control.
The code came up F2-E6. I changed the torch pad and having the same problem.
Answer Hello Jim,
Since this is not a valid code on the tech sheet for the appliance, the issue is going to be the control board 4452242. Since the board is no longer available, you will need to contact corecentricsolutions.com and make sure they support this board. If they do, you will have to send it to them for repair. You should take several pictures of the wiring to the board from different angles/directions so you will not have issues re-connecting it when it is returned to you.
Note: This question is for the older version of this part, but we thought you might still find it helpful
We have a Whirlpool oven model RBD305PDS15. The oven has shown a PF message on the display for the past few weeks which we could reset and the oven work. Now there is no display and it only beeps when you press the keypad. I've checked only and it seems that I need an oven control board. I've seen several different parts numbers and don't know know which one to order. I've seen 8302319, W10406070, and W10438751. Which one should I be looking for? Thanks.
Before ordering the control board you will want to check the transformer first. On the control board you will want to check the P16 connector from pin 5 to7 for 120 vac going into the transformer 9760587. If there is 120 vac then check same connector pin 2 to 3 to see if there is 12 vdc coming out. If not then the transformer is bad and would need to be replaced. If there is then the control board W10406070 is faulty. If there is not 120 vac going to the transformer then the control board is faulty.