The compressor is warm but does not run. Replaced capacitor, overload and relay from compressor but still does not work.
With having replaced the overload, relay and capacitor and the compressor getting warm but still not turning on then the issue with the unit would be a faulty compressor.
The temp in the refer side is rising, it's 50 degrees inside and temp is maxed out on the coldest selection,thanks
Answer Hello Bob. Is there frost on the back wall in the freezer? If so, It sounds like you may have a defrost problem with the unit. If so, you will need to test the defrost heater and the defrost thermostat. They should read closed for continuity when cold. You can test this with a multi-meter TJMA-DMT3. I will include a link at the end to assist you how to use the multi-meter if needed. If both parts are good, you will need to replace the defrost timer. Once the problem is repaired, you will need to thaw out the ice on the coils before the unit will operate properly. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html
I would like to know is there away to know if this sensor is bad. My freezer is cold but my refrigerator is warm.
Answer Hello Mike. If the unit is running, then the control 61005516 is working. You will need to check and see if there may be a defrost issue, bad fan motor in the freezer, or a bad damper assembly in the unit.