I changed the belt, and removed the blower housing to do it, and now there is no heat in the dryer, nor air. it worked for about an hour, then cut out.
Dave for Model Number LTE6234dq5
Answer Dave, Does the motor run, did the belt come off, or did the blower wheel jam or get blocked, or an "open" thermal fuse on the heater? We'll send you some Information that should help you out.
I have changed the heating element and fuses and I still do not get heat. Any suggestions on what might be wrong?
Debra S for Model Number LTE6234DQ5
Answer Hello Debra. You will need to unplug the heater and test and see which wire is dead. Then, trace the wire and see where you are loosing power at and replace that part. Be careful as you are dealing with live power here. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html
So if it does not cycle what is the problem?
Bob for Model Number lte6234dq1
Answer Hello Bob. You need to check and see if the cycling thermostat is bad or if the heater is grounded and needs to be replaced in the unit.
How will I check to see if the element is cycling?
Bob for Model Number lte6234dq1
Answer Hello Bob. You test it with the multi-meter. You disconnect the vent and insert the temp probe into the vent pipe and see if the temperature goes up and then back down. and continues this cycle.
My dryer runs for 10 to 15 minutes and then shuts down and will not restart.
Joe for Model Number YLTE6234DQ0
Answer Hello Joe. If the dryer runs for 10 to 15 minutes and then shuts off, and does not start again until it has cooled down, you may have a bad motor on the dryer and the motor 279811 will need to be replaced.
Is there a moisture sensor in this model, if so, where is it located?
Jose for Model Number wet3300sq1
Answer Hello Jose. There is not a moisture sensor on model WET3300SQ1. I hope this info helps!