Customer Questions and Answers for Drum Support Roller by Whirlpool

David for Model Number 1108892601

Answer Hello David. The drum support rollers are sold individually. Have a great day.. 

1 person found this answer helpful.

Ron H for Model Number 110.85872400

Answer Hello Ron. You need to order 4 rollers. 

Keith for Model Number GEW9200LW0

Answer Keith, You will need part number W10512946 for the triangle clips. 

Robert P for Model Number ymedb400vq0

Answer Robert, If you check the blower wheel and there was no lint clogged up on it causing it to go off balance and vibrate then the rollers would be the most likely cause of the unit shaking and vibrating. 

Dudley for Model Number sde4606ayw

Answer Dudley, the rollers aren't going to be the issue, unless they make nosie, Youmamy want to check, clean, and lubriacte the shaft and roller bearings. You do want to check the tumbler RPM, place a piece of tape on the end of one of the baffles, select air dry/fluff and hold the door switch closed and start the dryer The drum should rotate at 50 RPM(+/- 2) If the RPM is in range, you'll need to review the loading instructions for the dryer, and / or install a Baffle Kit 12002559 to reduce the bunching up of the articles. 

Lito for Model Number 110.77862600

Answer Lito, The most common problem with squeaking noise on dryers is the rollers being bad. You will want to check the rear drum rollers and check the idler pulley to make sure that they are not dragging. 

Gabriel M. for Model Number whirlpool WED6400 elec dryer

Answer Hello Gabriel. It is best to order and replace the kit 4392067 for the issue you are having. 

Carl for Model Number kenmore 1109758821075882

Answer Hello Carl, There are four W10314173 in this model. Two in the front and two in the rear. Don't forget to check the idler pulley 279640 while you're in there. Model #11097588210 

Patrick for Model Number Mgd9600sq0

Answer Hello Patrick, Dryer Repair Kit 4392067 likely contains most of what you need. It contains the belt, 4 drum rollers, idler pulley, tri rings, washer, and instruction sheet. Hope this helps! 

Steve H for Model Number Whirlpool GGW9250PW0 new 2004

Answer Hello Steve, Based on the model number provided, 4392067 is the correct kit for the unit.