When I turn the select dry knob the dryer turns on without pushing the start button, what part do I need to change to fix this??
Answer Hello Don. You need to check and see if the push to start switch 33001618 is bad. If so, This part has been permanently discontinued by the manufacturer and we don't know of any source or replacement for the part.
I open my dryer and the belt it's just crack. I clean the rollers and the pulley , it works fine for a while but then the drum has a hard time trying to spin when i put a new load in it. What part do I have to replace?
If the belt is cracked then you would want to go ahead and replace it. When the dryer heats up it may be causing the belt to stretch with heat and not allow it to grip properly to turn. Also check the rollers on the unit to make sure that they are not damaged.
How do I access the belt? Do I remove the bottom panel to get to the belt?
Answer Hello Frank,
You can remove the bottom panel to get to the belt but to remove and replace the belt you would have to remove the front panel and drum.
How do I get to the belt and take it off.
Answer Hello Bruce,
If you could provide an email address we could send you some instructions on how to replace the belt.
What is the correct part number for the dryer drum belt?
Answer Hello Mike. Based on the model number you provided, 33002535 is the correct dryer belt.