Note: This question is for the older version of this part, but we thought you might still find it helpful
How difficult is it to replace the coil in the bottom oven?
Answer Hello! You will have to disconnect power. Remove the two mounting screws holding the element. Carefully pull the element out until you can get to the wire terminals. Unplug the wires from old element and plug them into the new element. Re-install the element to the back wall. Don't forget to reconnect the power. Hope this helps!
3 people found this answer helpful.
Replaced lower oven bake element, still won't heat up,what are the options? Thanks.
Answer Jose, you'll need to test for 240v going to the element. If you have 240v @ the element, replace the element. If the board is not sending 240v to the element you'll need to replace the board, part number 5701M403-60. Thanks!
Range came with the house. It has always cooked about 30 degrees too hot (put a thermometer inside) in the lower oven. Top oven burns the bottom of things also (so that may have the same problem). Recently, our bottom oven heating coil broke. Would a bad coil be the reason the oven was cooking so hot or is it likely there are other issues? Trying to figure out whether to fix or get something else. No idea how old this is, but maybe 9-11 years based on other appliances in the house.
Answer Hello J.,
The element burning out would produce higher temperatures but that would only be during and up to the failure. The more likely suspect would be the temperature sensor (7430P044-60 upper oven sensor or 12001656 lower oven sensor). Remember, this is an electronic component that is exposed to high temperatures and failures are common and expected from them. You can test it from the board for about 1100 ohms of resistance at about 70°F. The sensor should be tapped on during testing in case of intermittent connection. If it fails the test, you should test it again from the sensor connector. If it passes, look for a problem in the harness 74009963 between the sensor and the control. If it fails again, replace it.
What may cause the baking element to melt down?
Answer Hello OK. Over time bake elements break down and can burn up. Usually it is caused by food spilling onto the elements, but that is not always the case.
We replaced the bottom stove burn element. The oven heats up to the temperature fine but the food is not cooking all the way thru. Any suggestions. I have tested this with foods and end up using the top oven unit to finish cooking the dish.
Answer Baffled Baker,
You will want to check the oven sensor to ensure that it is good. You would want to do a resistance check on the sensor and at room temperature of 77 degrees should read 1090 ohms. If not the sensor would need to be replaced.