What do you mean the element w/limiter? What is the meaning of w/limiter?
Answer Hello Laila. The limiter is made onto the element. It is used for the correct temp.
How do you raise the top to replace the element?
Answer Hello Robert. Open the door and remove the screws under the front lip of the cooktop and lift the top upward to access and replace the element.
The left front burner for my Magic Chef 3867VVV stopped working.
Is this the right part to fix it?
Answer Hello Mohammad. If the element is reading open for continuity, you will need to order and replace the element.
Will part #ap4092999 work on my magic chef?
The correct 6" element for your unit would be part number 12500039.
Replaced 6" element on Crosley glasstop stove. Now when I turn it on it acts like its on high setting even if on low. All other burners are normal.
Answer Hello Jason,
It sounds like either the limiter is bad on the element or wired incorrectly. We could assist better with a model number for the unit. Please post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx
I ordered a 6" element for my Jenn Air electric range. The instructions that came with it say to compare my old element limiter with the new one, and change the position of the wires on the terminals based on the new diagram, as the terminals ie. 1A, 1B, 2A, 2B are in different locations. Acutually 1A is a fixed jumper, so that location did not change.
I spliced in the extra lenghts of wires that came with the kit, and installed the terminals per the new diagram. When I turned on my knob switch, the light came on but the element does not heat up at all.
Answer Michael, You may have wired the element assembly wrong. Regardless of the instruction sheet, you need to verify the terminal locations on the new element limiter as compared to the original. and attach the corresponding wire to the corresponding terminal, ie, the 1B terminal should have the red wire, common to all the 1B terminls on all the elements, 2B should have the yellow wire that attaches to the hot surface indicator light. The 1A terminal has the metal jumper, and the 2A terminal should have the yellow wire from the H1 terminal of the infinite switch attached to it,the remaining yellow wire from the H2 terminal of the infinite switch will attach to the terminal on the side of the element housing. If you check and you're sure the replacement element is wired in this configuration, then you'll need to check for 220-240 VAC across the yellow wires (side of element and 2B) with the switch on, to determine if the infinite switch is at fault.
6 in element shown in picture has a different connection. Mine has 4 legs and 2 legs, picture shows 2 legs connected together. Maytag mer5730AAW serial # 1449.Mfg. Part # is 74002653 how do you connect the wires ?
Answer Hi. The element part # 74002653. The double red wires connect to the element 1b terminal. One of them comes from the 1b terminal on the left front elemt. and the other one is from the 1b terminal of the rt rear element. The red wire from the hot surface indicator lights connect to the element 2b terminal. From the 12 pin disconnect plug on the surface burner wiring harness the # 1 wire connects to the element terminal. The # 3 red wire both connect to the sensor left open on the side of the element sensor "block". Thank You.
Which is the correct element for magic chef Serial # 173327759WW?
Answer Ariel, according to your model/serial combo the replacement 6" element is part number 12500039 and the 8" element is part number 12500038. Thanks!
Which one of the two burners listed do I use for the above Maytag stove?
Answer Hello John! We will need your Range serial number to help verify the correct elements used on your CHE9830BCB model. Thanks.