What is the procedure for replacing the front panel, and how do the top spring,s 22001650 fit on the panel ?
Answer Hello Bob,
To remove front panel you will push in on the spring clip on either side between front panel and main top. Lift top and remove 2 screws holding front panel in place. Once you do this the front panel can be removed.
Are there any instructions available or online videos that shows the correct installation of the Spring retaining clip or the fastner spring 22001650 to reinstall the front panel on my washing machine.
Answer Hello Bob,
There are no instructions or videos for installing the spring clip. The clip attaches to the retangular opening on the top of the front panel of the unit. There is one on either side and the curved part faces forward.
WASHER HAS FILLED WITH WATER. ONCE WATER LEVEL WAS ESTABLISHED WATER STOPPED. BUT WILL NOT START TO WASH. THOUGHT MAYBE IT WAS THE SWITCH ON LID BUT THAT DID NOT HELP.
Answer Wooty, Did you check the inline fuse obn the lid switch for a "closed" circuit or 120 VAC on each side of the fuse? You also want to check for a closed "circuit" on the check switch (red wire to double yellow wires) with the lid down. If the switch is not closed, there won't be power to the motor and it won't run. and the other switch has to have a "closed" circuit from blck to the double red wires, or there won't be power to the check switch. Good Luck and Thanks
I have a 2008 Amana washing machine,stainless tub,super capcity plus/sofsound
1/3 speed select/710 rpm. when the spin cycle starts it is so loud u think it's getting ready to fly out the door. please help me fix the problem.
Answer Roger, can you isolate the noise to a specific area, bottom of the washer, bottom of the tub, top of the tub etc. At this point it sounds like you have a worn out spin bearing/milk stool and or tub bearing assembly,W10116790 , 40004001, it's a pretty involved repair, but it's do able. Thanks.
How do I open this model of dryer (i.e. top and front panel) so that I may access the drum and support rollers for inspection and replacement?
Answer Hello Greg! Here is the information supplied from the manufacture on how to remove the top and covers:
Console: Disconnect power supply. Remove control panel assembly. Remove eight screws, two on each side and four across the front, holding console to top cover.
Top Cover: Disconnect power supply. Remove fron panel. Remove two screws (one in each front corner) which hold top cover to cabinet. Remove main wire harness from components on control panel. Remove control panel assembly. Pull main wire harness through opening in top cover. Remove console. Push top cover back to disengage from cabinet and remove top cover.
Cabinet Removal: Disconnect power supply. Remove front panel. Remove top cover assembly. Remove tumbler. Remove tumbler rear. Remove six screws (three on each side) holding cabinet to base frame.
Hope this information helps!
Do the tops to Magtag washer just pull up, like in the old days? Do you reach in tub and pull up to be able to install the part that the water goes into the tub?
Answer Hello Tina. On the LAT models there are two screws at the bottom of the front panel that needs to be removed. Once removed, the front panel pulls out from the bottom to take off. Then there are two screws holding the top assembly in place, remove these screws and the top will lift up to change the water valve. Hope this helps.