What is the difference between model number nfw7200tw10 and tw11?
Answer Hello Len! Unfortunately, we do not have the specs to verify the difference in the two models. Sorry about that!
I have an Amana NFW7200TW and the door sags down and wont latch unless you lift it up and push bottom in otherwise it leaks all over the floor do I need to just replace the outer door plastic?
Answer Hello Neal,
This is most likely the door hinge assembly 34001429. You should also check the seating of the glass into the door boot. Anytime any hairs accumulate, be sure to clean them from the glass since this will cause leaking.
Need to replace front door, however it states it`s not available are there any other solutions?
Answer Hello Roger! Unfortunately, the aluminum colored outer door 8182151 and Tuscan silver outer door 8183070 listed for your model MFW9700SQ0 has been discontinued with no further replacements or cross references available and our company is unaware of any other available sources. Sorry about that!
We have a Amana front load washer and the door has cracked and come apart on the upper hinge, the bottom it cracking too -due to stress of only one hinge holding door on. Is #AP44601 the only part I am going to need to fix this?
Whether more needs to be replaced or not will determine the extent of the damage. You would need to replace the front door frame 34001424 if it is damaged but will also need to check the inner door frame 34001426 and hinge 34001429 to make sure that they are not damaged.
Part arrived,(PN 34001424) and I installed but there is a leak between the clear glass of door and the ring around the glass. Is there a gasket to seal the gap or can I use some silicone grout? Thanks. Larry
Answer Hello Larry,
Water should never reach the area you are referring to. The water seal should take place between the door glass and the door boot 34001432. If water is getting past this seal, the door boot will require replacement to correct the issue.
I just ordered a door frame item #AP4044601 for my Maytag Neptune front loader washer. Will we be able to install ourselves. The metal hinges are intact that attach door to machine, only the plactic door frame is cracked. Please help. We have had this machine repaired many times and would like to install if possible.
Answer Karen, Yes, this is a repair you should be able to perform, easily, and basic hand tools is all you'll need. Here's some help " Door Removal
1. Disconnect power supply to unit. 2. Remove four screws (on the inner door assembly) to remove door from Front Panel.3. Remove hinge retainer plate. 4. Remove door from hinge posts. 5. Remove Screws around the perimeter of the glass retainer. 6. Remove the glass retainer. 7. Remove glass. 8. Remove external viewing window." Thanks