How do I reinstall the spring and cable on a door boot that I just purchased from you and the spring is impossible to strech.
Answer Hello Mony. These are very hard to do, but you will use 2 pairs of needle nose pliers and stretch the spring until you can hook it into the loop. Again, these are very hard to install onto the unit. If you have a friend to help, it does make the job easier with 2 people.
What front door seal do I need for my whirlpool washer?
Answer Mary, the door boot seal 8181850 is the correct seal used on your model GHW9100LW1. Thanks!
Hi, is this bellow the correct one for GHW9400PW1? Thanks!
Answer Arend, according to your model number GHW9400PW1 the replacement bellow should be part number 8182119. Thanks!
What is the correct bellow part number for model # WFW9400SW00?
Answer Hello! The replacement bellow used on model WFW9400SW00 is part number 8182119. Thanks!
Which tub seal do I need for wfw9150ww00?
Answer Hello Tammy. Based on the model number you provided, W10381562 is the correct front tub bellow. Hope this helps.
Have water in the softener bin after a wash.
Answer Hello Ed. Remove the drawer from the unit and disassemble the drawer 8540402. Now clean each port and cup with hot water. This should take care of the issues. If not, you may need to replace the drawer. You can also tilt the front of the washer with the level legs, so it lean just a little backwards to help with this. Hope this helps.
What is the correct part number for the front bellow tub seal?
Answer Joan, according to your model the front bellow tub seal is part number 8181850. Thanks!