I get an F-3 and F-5 codes for the stove. I assume its the oven temperature sensor. Is that the snap disc switch on top? The fan will come on occasionally. I checked for shorts, but I don't know if the relay on the control board could acting up. Also, F-5 says replace the clock. Is that the display board? Help! Thanks
Answer Hello Kevin,
This sounds like you will need to change the temperature sensor 12001656 and the ERC. This is of course a preliminary diagnosis based on the initial fault codes. No parts should ever be ordered until all electrical connections have been dis-connected and reconnected one at a time. Of course the reason for this is the fact that many failures are caused by poor electrical connections. The fault codes are listed by the manufacturer as follows:
F3--Open oven temperature sensor. Replace oven temperature sensor.
F5--Supervisory relay enable open(cook mode). Replace electronic range control(ERC).
The clock is the part with the display 71002331.
Hello - From your diagram it looks as though I can access the high-limit thermostat through the back panel. Is this correct? Thanks.
Answer Hello David. No, to access the thermostat 74009837, you will need to go through the top of the unit. Remove the grill pans and the 4 screws that mount each pan to the main top. Remove 2 1/4" hex screws and replace the thermostat.
The cool down does not shut off = blower runs for days! The problem started by gradually increasing the cool down period to an extremely long period of time; now it will not shut-off at all!
Answer Hus, You most likely have a stuck fan motor relay on the auxillary relay board 12001690A (71002144). Since you have no cooking issues or other control complaints. The circuit for the cooling fan is a bit elaborate but , the oven temp. sensor sends a resistance reading to the ERC/control, when the temp. reaches a certain degree or the same resistance is there for an extended period of time, the control sends a circuit to the relay board, the relay closes and the cooling fan runs. When the oven temp. cools down and the resistance is in the normal range, the relay opens and the fan shuts off. The aux. relay board has been discontinued by the manufacturer, you may have to shop around to find the part. Thanks and Good Luck
When putting the door latch in locking. It will not lock with oven off or when placed in cleaning mode.
Answer Hello Les. If the latch assembly is broke on the unit, and it does not lock, you will need to replace the latch assembly 12001106. It sounds like the latch assembly is broke, and is binding up. Hope this helps.