How easy is this to install?????
Answer Hello Kevin. These are not to hard to install. Just remove the screws holding the icemaker in place, and disconnect the wires to the icemaker. You will need to remove the arm from the old icemaker and install it on the new one. Reinstall in reverse order. Hope this helps.
1 person found this answer helpful.
Is a model number w10190965 ice maker the correct replacement for model number 4317943?
Answer Hello! According to the model number given the replacement icemaker for your appliance is part number 4317943. Thanks!
We recently replaced our ice maker because the old-one was leaking inside the freezer. It was pretty simple, 3 screws and the wiring harness. The refrigerator is a 2005, and this is the first part I've had to replace. Since then the new ice maker is working producing ice, with no internal leaks. However the cycle seems very slow, (compared to when the whole unit was new). When the unit was new, it would fill the auger bin over night. Basically empty the auger bin into the bottom bin before I went to bed, and by next morning (8hrs) the auger bin was full again. In the last 6 months or so I'd say the old Ice maker was running notably slower as well, and then it got to causing a stream of ice to freeze from below the front of the unit into auger tray, so I figured it was time to replace it. Now in an 8 hour stretch with nobody taking any ice, the auger bin is only 1/3 full. The water supply seems UN-obstructed, as the door-valve flow works as before. Further more, I've taken a hair-dryer & coat hanger to freezer-side of the water inlet (trough) into the ice maker, and it appears unobstructed as well. Also I have shorted/jumpered the T to H connections and the motor-gear unit is rotating fine. Any help would be appreciated. Eric
Answer Hello Eric,
The ice maker actually has no control over how long it takes the water to freeze. I would suggest to check the condenser coils behind the unit. If they are restricted with a lint/dust build-up, this can cause the temperature inside the unit to be several degrees warmer which will adversely affect the ice makers' production cycles. You can also check the ice door with a flash light, (if light can pass, so can air). The door seals are also on the list of things to check. I have also had to remind customers in the past that checking on the ice maker causes a long cycle since, each time the door is opened, the longer it takes to freeze the water. As per the manufacturer, with the unit running at an average temperature of 0° to 10°F, if the doors are not opened for 24 hours, maximum ice production for a side by side is approximately 130 cubes. The crusher bin will actually hold over 300 cubes so your ice maker seems to be working as the manufacturer says it should. Be aware that dropping below 0° will cause a long harvest since this causes the ice maker to have issues with getting the frozen cubes out to re-fill.