What tool do you recommend to peal off the facade insert without scratching the facade, than how do you connect the wires to the new insert?
Answer Hello Darrell. You can use an ice pick to raise the edge and peel it off. There are no wires to connect on the insert 67004152. It is a sticker that covers the buttons. Hope this helps.
What do you use to pry off the facade insert after you have removed the two screws behind the drip tray?
Answer Hello Darrell. You do not need to remove the facade screws to replace the insert [AP4079284. You can peal the insert off the facade. Hope this helps.
Part AP4079284. How does this install?
Answer Hello John. 1. Remove drip tray by pulling it straight out from door.
2. Remove two hex screws at the bottom of facade that
were hidden by drip tray.
3. Push down on facade to release retainer clips.
4. Remove facade 67004152 and disconnect ten pin connector from
5. Reverse procedure to reassemble. Hope this helps.