I looked at old one it had 3 flat and 1round pin.
Answer Hello James. The left side on the range should have been a grill, not a surface unit. For the surface unit use on the left side, if the switch test good on the large and small elements, you will need to change the terminal blocks to work for a 4 pin cartridge, according to the manufacture. I sent you the service manual for the cartridge. Hope this helps.
I have 4 ap4291911. Do you have a wiring harness for them?
Answer Hello James. The wiring harness 702023 has been permanently discontinued by the manufacturer and we don't know of any source or replacement for the part. Thanks.
This is the model # c228 on stove.
Answer Hello James. Go to the small element switch with the power disconnected. Test across L1 and H1 and L2 and H2 and see if the switch reads closed across either test in the off position. If so, you will need to replace the small switch Y703147. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps.http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html
Mc228 I think that is right. It is the only model #mc228 I can find.
Answer Hello James. That is not the model number. That is a model number for a microwave. Use the model number locator link we sent you to find the correct model number. Hope this helps.
I have installed the new cartidge part # AP4116885 and when I cut on the switch for small switch works ok, but when I cut off the small switch and cut on the switch for the large element both elements burn at the same time. Do you think that it could be a bad switch? If so, do you have the switch for that unit?
Answer James, could you supply us with a model number of the range/cooktop? We will need it to determine if you have a bad infinite switch or the wrong element cartridge installed. A quick check for you to make, did the original cartridge have 4 flat blade and 1 round blade for the receptacle, or did it have 3 flat and 1 round tab? They are not interchangeable, and will not work properly in the wrong cooking bay. Thanks.
Does this part have 3 flat and 1 round pins?
Answer Hello James! Yes, the radiant element cartridge part number A122W is a 3 flat 1 round with prong on the end. This is a radiant quick start element module with black glass and white trim. Thanks!