My washer will not go into spin cycle. Would this be the lid switch?
Answer Hello Brian,
It sounds as though the lid switch 22001682 would be the issue.
How do I get the lid switch out?
Answer Hello Bobby. Disconnect the power. Remove the two inside screws on the back of the control panel and tilt forward. Remove wires from lid switch. Remove the screws securing the lid switch to frame. Reinstall with new lid switch in reverse order. Note: To adjust the lid switch, place a 1" block under the lid in the front. Slide the switch forward until a click is heard from the lid switch. Slowly slide the switch back until the click is heard again and hold in that location. Lock the lid switch assembly down. Hope this helps.
Washer worked fine on first load, put in second load and nothing, no noise at all completely dead. Checked fuse box and outlet both are OK.
Answer Hello Bobby. Based on the information you provided, it sounds like the lid switch 22001682 is bad and will need to be replaced. Check and see if the fuse in the lid switch is bad. Also, you can test the switches and make sure they are good. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html