Drain appears to be clogged. Water building up inside bottom of freezer. How do you unclog?
To clear the clog in the refrigerator you will use hot water to melt the ice in the drain tube. Pull the unit out and remove the lower cover. Access the drain and pay attention to how it is routed. Unplug the unit and remove the drain line. Flush the drain line thoroughly and reinstall the drain line.
I have a Maytag "Wide by Side" refrigerator and the water through the door doesn't work. When the switch is pressed, there is a click and the light goes on but no water comes out. There used to be a second click when the water came out but no more second click.
At the bottom of the door there is a connection for the water line. Disconnect the water line and hit the dispenser and see if water comes out. If water comes out then the issue is the water tube in the door being frozen and will need to be thawed. If not then go to the back of the unit and see if there is 120 vac coming to the water valve when the dispenser is pushed. If there is 120 vac then you either have a frozen water tank or the valve is faulty.
I have a Maytag Plus fridge. When I press the pad to dispense water and ice the button seems to stick and not release to stop water or ice. Could it be switch or pad?
Answer Hello Paulibra. For the issue you are having, you will need to order and replace the actuator pad 61003804 on the unit. You will need to apply grease on the button inside the pad to help in preventing the issue you are having. If you try the grease on the old pad, and the issue continues, you will need to replace the pad in the unit.
The entire fountain stopped working. The light on ice cube button is on and stays on. Any other button you push does not lite up or work. The lock doesn"t work either. The light for the fountain came on and will not go off ? HELP
Answer Hi. Remove the Fountain spill catcher. Remove the hidden lower screws and lift up and out to remove the fountain control panel. The control board unplugs from 2 wire connections. Make sure they are connected tight and are not pinched. If you have to fold the ribbon cable, fold it at a 90°. We have seen where both fountain boards are affected as both boards need changed as well. Replace the main board part # 61003425 and momentarily connect and test the fountain board part # 61003421 along with it. If it does not stop the continuous light and return normal commands then change both boards. It may be possible that you have taken a power surge at one time and wiped out both boards. Thank You.
Do you have any instructions on replacing Limit Switch # AP4069438
Answer Phil, Here is the help you need : "Ice and Water Fountain Bracket Assembly Removal 1. Disconnect the unit from the power
source. 2. Pull straight out to remove the grill from the fountain sump. 3. Remove the two escutcheon mounting screws. 4. Raise the escutcheon up and off the fountain assembly. 5. Disconnect the quick disconnect edge connector from the PC fountain switch board.
6. Remove the three fountain bracket mounting screws. Checking and Replacing the Actuator Switch: 1. Disconnect the unit from the power source. 2. Perform steps 1 through 6 of To Remove Ice and Water Fountain Bracket Assembly. 3. Check the continuity of the switch if defective go to step 4. 4. Remove the mounting screw. 5. Remove the switch. 6. Remove the wire leads. 7. Install new switch in reverse order of removal. Thanks and Good Luck
I changed the ice door fountain kit, but now the light dosent work so I cant change for water to ice.
Answer Hi Jose. There is a single wire , beside the larger pin connector that you had to unplug going into the kit. It is on the lower left side. This wire goes to the light neutral and the board neutral. Inspect the entire connections to the controls carefully and inspect all connections. Hope this helps. Thank you.