24/7 Customer Support

CHECKOUT
Items in Cart:
Total
$0.00

Customer Questions and Answers for Motor Start Switch by Whirlpool

  1. Our Price $51.95
    Compare At $67.00
    You Save $15.05
     
    • Part Number: AP3125984
    • MFG Part Number: 8529896
    • Made by: Whirlpool
    Add to Cart

Questions & Answers

For Whirlpool Motor Start Switch (Part Number: AP3125984)

Ask a Question

Most Interesting  |  Latest Questions

I have replaced my lid switch and my washer still stops on the rinse cycle. Timer, start motor cycle swith ? HELP. Thank you.

Joe for Model Number 110.92389200

Answer

Was this helpful?

1 Answer

My 11 year old Kenmore Elite washing machine makes a loud buzzing sound sometime when it tries to spin or agitate, Most of the time when it makes the buzz sound it stops trying to spin or agitate for a minute or two then it'll try again. When it does spin or agitates the buzzing sound is much quieter and shorter sounding. Ive replaced the coupling and the clutch but it's still acting up.

Jim C for Model Number 11023012102

Answer

Was this helpful?

1 Answer

My washer fills with water but nothing happens beyond that point.

Stella for Model Number 110-24872300

Answer

Was this helpful?

1 Answer

My washer goes through the wash cycle and when it comes time to rinse it just stops. What would cause this?

Billy for Model Number LSR7233EQ

Answer

Was this helpful?

1 Answer

I have a black soft button to push to start the washer and now when I push it nothing happens. Will not start or add water.

Carol

Answer

Was this helpful?

1 Answer

Washer will not spin.

Houston for Model Number LSQ8543JQ1

Answer

Was this helpful?

1 Answer

Motor hums, but if you turn by hand, it will run.

Roger for Model Number lsr5132jq1

Answer

Was this helpful?

1 Answer

I replaced the spin coupler, and I didn't tap the dogs on the shaft far enough so when I put it back together it was hard to turn . Before I checked that, I turned on the machine ,it filled with water and when it went to agitate it buzzed for a while then stopped . So I think I burned out the motor start switch . I corrected the dog on shaft problem and motor spins free and I get power to the motor but maybe I have to bypass or jump the water level switch. Can you help ?

Ralph for Model Number kenmore 110.28972890

Answer

Was this helpful?

1 Answer

Hi, I get a brief clicking noise when the washer either begins to agitate or spin. It is like - click, click, click, click - then it begins to agitate or spin normally. I checked the clutch and brake cam - still good, the motor coupler - still good, and the pump - still good. With the cabinet removed, I think that the noise is coming from the motor. Could it be the motor switch? I don't see any burn marks on the switch or the harness connector. I did check the motor terminals as according to this site - (http://www.applianceaid.com/direct-drive-washer-motor-help.php) - the measured resistance between the listed terminals falls within those specified,

James for Model Number KAWS850LQ1

Answer

Was this helpful?

1 Answer

Washer stopped agitating in the middle of a load. Assumed the clutch or coupler was bad. Replaced both which didn't look bad. Before putting motor back on transmission I set it on the floor and turned the timer to agitate and got nothing, on spin it ran fine. Where can I get a pin diagram for the motor switch or timer to see if I have voltage there? Any other suggestions?

Dave H. for Model Number Whirlpool 110-23034100

Answer

Was this helpful?

1 Answer

 

 
 
We are Safe, Secure, Dependable and Trusted
  • BizRate.com Customer Certified Site - Click to Verify