Not to be a pain, but the Appliance Compatibility Tool returns: "Sorry This part is not compatible." Find parts for model JMW9530CAS"
Are those parts any different from: AP4096704 and AP4096703?
Because those two are $101.24 as opposed to the $173.36 for the kit.
Answer Doug, the compatibility tool will not recognize the kit 12002111 offered for your model as it is not in the parts list. JennAir is aware of the issue of the doors not closing properly and made the kit suggested to correct their error. The hinge and receptacle in the kit are different than part numbers 74008014 and 74008015. Thanks.
both doors on my dual convection oven will not close completely, everything else works fine but the heat and humidity escapes from the top and I am concerned there will be a problem with the electronics if not repaired soon.........please help
Answer Mike it's a bit more involved than just door hinges 74008014 . You'd be bettwer served to order the door hinge/recptacled kit 12002111 (you'll need to partially remove the oven from the cabinet to access the receptacles (6 to 8 inches). Once the kit is installed, check and clean the oven door gasket with hot soapy water and start the oven in a four(4) hour self clean cycle.
How do you change door hinges on ww30430p?
Answer Hello Bob,
With a email address we may be able to send information with how to change the door hinge.
My oven doors do not seem to close all the way and make a tight seal. If you push on the doors when they are closed, they have some give. However this hasn't seemed to effect the function of the oven. How can I tell if it is the hinges that are faulty? Is there some kind of adjustment I can make or is there something else that can be causing this? Please help.
Answer Hello Chris, If the door is positioned on the hinges properly and it is still not sealing, it's likely your hinges 74008014 are the issue. Some have adjustment and some do not. If they cannot be adjusted to your satisfaction I would replace them. Also make sure your door lining is engaging the hinges properly. Sometimes it helps to take the door off and reinstall it to correct the alignment. Hope this helps!
I have a left broken hinge.and left broken hinge receptacle. and i am unable to latch it so in the lock position. The right side is pefectly fine. just the left side and i am unable to remove door. Is there any trick i can do so i can lock the hing and be able to remove the door. Anything is greatly appreciated. thanks
Answer Naji, under the circumstances, you may want to try using a pair of "vise grip" pliers or other small clamping device. open the oven door and set the lock on the working hinge. then clamp the pliers or device to the broken hinge and remove the door per the instructions. You'll need to replace the hinge, and the receptacle so any damage to those components would be corrected by the repair parts. Thanks
Whirlpool model W30400P. Is this the correct replacement hinge? Thanks.
Answer Hello Tom! Yes, the oven door hinge part number 74008014 is the correct replacement door hinge on your W30400P model. Thanks!