Got this new oven door trim kit and I would like instruction or some type of diagram on how to install the trim on the door.
Answer Nancy, Here are the basic instructions for working on the trim and oven door glass " 1. Turn off the electrical supply to the range.
2. Remove the oven door and position it on a protected floor with the handle and outer door glass facing up. 3. Raise the top of the door and remove the two screws that secure the top of the door trim and the handle to the door liner, then remove the handle and top trim.
4. Slide the outer door glass out of the bottom trim channel and install the new glass in its place. 5. Install the top trim and handle on the oven door and secure them in place with their two mounting screws. REASSEMBLY NOTE: The side trim on Whirlpool oven doors fits under
the top edge of the outer door glass, and the side trim on Roper models fits over the top edge of the glass. Make sure that the trim is
seated properly when you tighten the screws .6. Reinstall the oven door on the range." *** NOTE The new trim kit side rails will have plastic divots on the end, These divots will fit into the two farthest out screw holes in the bottom trim strip, and you will not use the two screws that mounted the original side trims to the bottom trim *** Thanks and Good Luck
My current white metal door trim bottom piece is rusting due to water running down the door and sitting in the groove between the glass door and the metal bottom piece. My family washes their hands and then dries with the towel that hangs on the oven handle. Is there a recommended caulk or sealant that I can use where the glass meets the bottom trim piece that will keep this from happening without discoloring?
Answer Hi Ron. Oven door trim kit part # 8184859. - Color: White. For black order AP3176314. For bisque order AP3176315. For almond order AP3177268. Kit includes two side pieces and one bottom piece. NOTE: This part has been redesigned by the manufacturer. The lower screws are no longer used and the side trim now locks into the lower trim with the dimples on the lower end of the side trim. You can use a 100% clear silicone to seal as you asked. Part # TJ441044. Thank You.
Do you carry the front glass door to the oven? Mine fell off and broke. I have the handle.
Answer Hi Pamela. Outer door glass (white) - Color: White. For black glass use AP3086282. For biscuit glass use AP3038947.
Part Number: AP3085052 made by WHIRLPOOL. Hope this is what you need. Let us know if we can help further. Thank You.
Is this the right door kit for my White-Worldpool gold super capacity 465 stove m# GR396LXGQ-0 SER# RJ0205587?
Answer Hello Jac! Yes, the oven door trim kit part number 8184859 is the correct replacement kit for your Whirlpool Range model GR396LXGQ0. Thanks!
We are on our third door trim kit for this oven. The door trim kit fits together nicely, but it does not allow room for the glass to be put back on. PLEASE HELP!!
Answer Kary, You do have the oven door off the range and on a coverred table, and you are doing this in a 4 step process, insert the glass into the slot in the bottom of the top door trim/handle trim, insert one side trim in until flush with the door trim, then repeat for the other side, then insert and attach the lower trim to the bottom of the door liner with the 2 scews, the 2 end screws have been eliminated and there are plasic studs that insert into the openings on each end of the bottom trim panel, Hope this was helpful, Thanks