Questions and Answers for Whirlpool 9758079 Oven Igniter page 2

Total
$0.00

Our Price	$35.49
Compare At	~~$45.58~~
You Save	$10.09

The oven clicks like it is trying to ignite but it wont light. I pulled the bottom and flame spreader out and tried to light oven again but didn't see a spark from the igniter. It did however light using a match. Is the igniter the problem or is there another part that could cause it to not light?

Joe G. for Model Number MGR7775WW2

Answer Hi Joe. Use a volt/ohm meter part #@ TJMA-DM1 to assist you in your diagnostics. A cold igniter part # 9758079 ohms out to no less then 50 ohms to 500 ohms. If lower then it is shorted, if higher it is open. If you can see a crack in the middle it is open. It is a very common issue with gas ovens. Thank You.

Was this helpful?

Yes

1 Answer

The broiler lights, but the oven doesn't spark. The display starts a countdown for preheat, but the oven does nothing. Is my ignitor bad or do I have control board problems? We tried unplugging and it did not help.

Pat for Model Number sf367lek (whirlpool range)

Answer Hello Pat. Check the igniter 9758079 and the wiring for the igniter and make sure they are not broke. If both are good, it sounds like the spark module W10331686 may be bad and will need to be replaced. Hope this helps.

Was this helpful?

Yes

1 Answer

while cooking the turkey the control/clock panel went out and the oven shut off. The ignitors still lit the top burners. I disconnected the power to see if the panel would reset but it did'nt. If the oven ignitor went bad would it shut down the electronic control panel or is the control panel the likely problem? I'm hoping for the least expensive fix.

Bob for Model Number wfg361lvs0

Answer Hello Bob. Based on the information you provided, the control W10424330 is bad and will need to be replaced. Hope this helps.

Was this helpful?

Yes

1 Answer

The bake and broil option on my whirlpool accbake oven stopped working.It makes a clicking noise as if to light but doesn't.The top ranges, clock, and timer all work. Never used the self clean and had unit about three years. Is this an igniter problem (was informed it has a igniter for the bake and one for the broil and both to go out at same time is strange) or a board problem

Mitchell for Model Number sf362lxtq 0

Answer Hello Mitchell. Check and see if the igniter in the oven is sparking. If not, test and see if there is power coming from the control to the spark module W10331686. If so, and no spark, replace the module. If there is no power from the control to the module, you will need to replace the control W10114384. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html

Was this helpful?

Yes

1 Answer

I am looking at the oven igniter AP3594295 and don't see how it is connected electronically. What is the trick? Does the ceramic end just plug into something?

Phil for Model Number wfg631lvb1

Answer Hello Phil! Here is a link from our free repair forum with information regarding the installation process of igniters, hope it helps! http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/1332-help-instructions-install-oven-igniter.html

Was this helpful?

Yes

1 Answer

Customer Questions and Answers for Oven Igniter by Whirlpool

Oven Igniter

Questions & Answers

Most Interesting | Latest Questions