I am told I need a new control, can I install the panel myself?
Yes, the control board would be able to replace the control panel by removing the screws on the inner panel of the door. Once they are removed you will lift the door and remove the control board latch and vent assembly. You will then take the screws out holding the control panel in place.
What all comes with the control panel? Does the circuit board come with it? Thanks
Answer Hello John,
The control panel 6-919818 has the membrane switch built into it. If you order it you will get the control panel with the membrane switch factory installed into it.
Heavy, normal, & light are the only lights that come on on the panel. Nothing else lights up?
Answer Hello Bob. It sounds like the control panel needs to be replaced on the unit. Make sure the ribbon cable is clean and connected good on the unit.
Received error code hE after about 10 minutes of the gas dry running.
The hE is a heater error. It indicates an invalid heating temperature in running the dryer. Check for a restricted vent system and check the thermistor resistance. The thermistor resistance should be 10K ohms @ 77 Degrees Fahrenheit.
What is the part number for the stainless steel version of the control panel? Model Number MDBH945AWW.
Answer Robbie, the manufacturer does not offer a stainless control panel. The stainless models use a black control panel part number 6-919833. Thanks!