The freezer drawer does not stay closed. It used to have something that drew it in on the last inch or so Now that is not happening and the drawer either does not close, or closes but pops out when one of the upper doors is closed.
Answer Rick, You'll need to remove the drawer from the rails ( Open drawer to fully open position. Remove upper basket. Remove screws one in each rail marked on side of rail. Lift front of drawer up and out to remove drawer) Then remove the drawer slides W10120018 (Remove screws inside plastic rail retainer. Remove rails from retainer by depressing plastic tabs on back side of retainer. Slide rails off of retainer.) Then you can check the black plastic rail closer and springs for damage and operation. You also want to check and make sure the rack and pinion gears are installed properly and aligned and synchronized. (Remove drawer assembly. Extend drawer rails to full open position, remove rails from retainer by depressing plastic tabs on back side of retainer. Slide rails, rack and pinion gear off of retainer.
Reverse procedure to reassemble. Note: When reinstalling rails, rack and pinion gear after latching rails in place, slide rails, rack and pinion
to the fully closed position and then pull out to synchronize the rack and pinion gears.
Need hinge for slide drawer- left side hinge.
Answer Don, the left pantry endcap is part number 12656106. Thanks!
Can you tell me how to install this part onto the pantry endcaps?
Answer Hello Robert,
You slide one side onto the endcap and then you kind of push in a little on the peg on the other side and slide into place. If either peg is missing you will have to replace that endcap.
I spilled something and easily removed the Pantry Lid to clean it. Now we are unable to replace the lid so that it seats properly and allows the lid to lift and lower when the drawer is opened and closed. Maytag Customer Service told me to call a repairman!
Answer Hi Cathy. We looked back as far into 04' complete history of reports @ all WPL. fridge models /information and found no reports @ this issue. This pantry lid has a Guide on each upper corner that will gently bend in as you insert it into the opposing track. Pantry lid part #67005903. I know by personal experience it is not easy to do. You install one corner first and then go to the other corner guide and place it tin the track. It has a particular place on each rail side to slide into . This will work smoothly after installing it. Thank You.