Mixer has only one speed--Fast.
Answer Hello Dan. You will need to check the phase control board W10325124 and see if it is bad. Hope this helps.
1 person found this answer helpful.
My mixer does not have a stir speed. It goes to med-high. I have replaced the switch control panel, but now I can't adjust the switch to the proper speeds.
You will want to check to make sure that they wiring to the control board is correct and if it checks ok then the speed control plate would be the most likely cause for the issue.
My mixer will not turn on. Checked outlet and it has power.Which part do I need ,phase board,control board or both.
You will want to check the speed control plate W10119326 to make sure that it is good. If that checks ok then most likely the phase board would be the issue W10325124.
The mixer sometimes won't change speeds above 6, then will turn off when brought back down to 6. The plate control is cracked around the bottom screw. Could this be the problem? Thanks!
Answer Nancy, Yes, a cracked control plate W10119326 could cause the issue, The plate could "flex" or twist and reduce the circuit to the remainder of the motor drive components, causing a partial operation, there arte other components to check and adjust, but the plate will be a good place to start.