Washer won't drain water, the drain hose are ok?
Answer Hi Jose. If the drain pump part # W10536347 is inoperative with the 120 vac in drain or the impeller is loose on the shaft then you need to replace it. Thank You.
remove coins from under washer drum
Answer Mike , To clear coins etc. from the inner basket you will need to : Remove power to the washer,Tape the washer lid closed. Using a putty knife, press and unlock the two front top locks. The locks are approximately 6-1/2? from the outside edge of the washer. raise and prop the top against the wall or use a prop rod. 1. Unplug washer or disconnect power. 2. Raise the cabinet top.3. To remove the basket:
a) Loosen the clamp and pull the recirculation hose off the tub ring. b) Pry out and unsnap the tub ring tabs from the tub and remove the tub ring. c) Insert the blade of a small screwdriver into the slot in the impeller cap, then pry the cap up, and remove it. d) Remove the 7/16? hex-head bolt from the impeller, then lift and remove the impeller from the basket. NOTE: Lifting the basket will assist in removing
the impeller. e) Lift the basket out of the washer. 4. To remove the basket hub, remove the six screws, and lift the hub assembly from
the basket. 5. To remove the lint filter, remove the two screws, and lift the filter from the tub. NOTE: Clean the lint from the vanes in the
filter and reinstall it in the washer. Reverse the procedure and check for operation." Thanks and Good Luck.
Is there a screen kit to stop small coins from getting into the pump and breaking the black impeller housing.
Answer Mike, no , there is no screen kit for the drain system, Nor is there any reccomendations to do so. It would create a drain problem eventually causing the washer to malfuntion. You'll need to be more cautious about checking the pockets of the articles when loading the machine. Good Luck.
CAN I FIX A WATER PUMP IF ITS LEAKING INSTEAD OF BUYING A NEW PUMP?
Answer Hello! If the circulation pump W10233462 is leaking you will need to replace it. Thanks!
What makes a pump go bad and/or how do you know if its bad or not?
Answer Hello Anthony. Things wear out over time. You can test to see if you have power coming to the pump with a multi-meter. If you have power, and the pump won't run, then you will need a new pump. Hope this helps.