Need to convert LP dryer from LP to Nat gas. What parts do I need? THANKS
Steve Van Houten for Model Number LGR5644JQ2
Answer Hi Steve, to convert LP gas back to NAT gas, order orifice 234826, limiter 694424, regulator screw 694423, and regulator spring 694422. To convert from NAT gas to LP, order kit# 49572A. Thanks!
I purchased this range used and I need to convert the range from LP to NG. What parts do I need?
Alvin for Model Number KDRP467KSS
Answer Alvin, you will need to convert the orifices back to NG. The orifices are only available with the holders. You will need four turbi W10155786 and two auxi 9782447. Flip the pin on the regulator back to NG. Thanks!
Need to know what I need to convert both these units from propane back to natural gas. Would appreciate your help. Thanks, Dave
Dave for Model Number Magic Chef YG20JN4, Kenmore 11070952990
Answer Dave, on Magic Chef model YG20JN4 the entire valve will have to be ordered if the original parts were not kept. The valve is part number 63-6786N, this item has been discontinued and is no longer available. For Kenmore model 110.70952990 you will need the orifice 234826 and the limiter 694424. Thanks!
I am converting this from LP to Natural Gas. I replaced teh regulator screw. What is the initial setting for the screw. How do I know if it is set in the correct location?
J. R. A for Model Number 110.87683110
Answer JRA, There are four(4) parts involved in converting the gas valve back to Nat Gas, spring 694422 regulator694423 cap694424 and orifice234868, all the LP Gas parts will need to be removed and replaced with the NAT Gas parts for the unit to operate safely and properly. There are no adjustments to make, other than the air shutter on the burner. All the fittings need to be snug and tight, and checked for gas leaks with soapy water. Thanks and Good Luck
We recently purchased an igniter , and themal coils, installed these. The problem still exists, the originsal problem being, it turns on, flame comes on, then it turns , the flame turns off, that had been the problem all along
Norma L. for Model Number dg210
Answer Hi Norma. There is a flame sensor that is directly to the left of the ignitor. It is always normally closed but will open the circuit as the flame reaches temperature. This part # is 338906. The high limit switch will shut off as a safety also. This part # is 338906. Please let us know if we can further assist you. Thank you.