Model # MGR4452BDO rear stove top igniters are inop. No spark. fronts are sparking in unison and working fine. any suggestions. is it just igniters or half the module is bad?
You will want to pull the burner heads off and check the ignitors for cracks. It is possible that the ignitors are bad. The spark module would be less likely but still a possibility. To check the ignitor you will look for cracks and check continuity. If there is continuity then the ignitor is good.
I was hoping you could tell me where the spark module for my Whirlpool range is located.
Answer Hello Brad. The model number you provided is not working. This should be located in the bottom back side of the unit. Yoou may have to remove the back panel to access the part.
All the burners are sparking all the time with no burners turned on.
Answer Mary, You may need the spark module 8215557, but with your particular complaint, you need to check the igniter switches W10180490 on the burner valves first. If one or more switch is stuck "closed" (on position) or a wire is shorted to chassis ground, the igniters will continue to spark.
The 110V broiler element does not work on my oven. I ordered a new element and replaced it and it still does not work. What else could be wrong?
Answer Bubba, You may have a broken or damaged blue or white wire to the element, or a faulty relay on the ERC / Clock 5760M305-60. If you have access to a multimeter, you can remove the element, attach the meter leads to the wire terminals, and select a broil setting, you should read 120VAC across the wires, if not you'll need to check the wires for damage and breaks. Then check the E/BR terminal on the back of the ERC for 120 VAC to chassis ground when broil is selected, no 120 VAC would indicate a faulty relay and you'll need to replace the ERC.