My control panel will not work after installing a latch assembly. The control panel is flashing the letter L. Also the number 3 light indicator stays on.
Answer Hello Richard. You will need to check all the wiring connections on the unit. Also, make sure when the latch is closed, it is making contact with the switches in the unit.
i disconnected the door switch and put it back in wrong. now i cant get if pulled back out and my dishwasher fills with water but wont start the cycle. is there a trick to getting the switch pulled out and also a diagram of how it plugs in properly? i did it a while ago and cant even remember which one i pulled out. thanks
Answer Matt, The switches, are locked in place by a plastic clip on the latch assembly. There are also pins on the door that the openings on the switch slip over to proper align the switch. Remember, the wire terninals face down towards the bottom of the door and the switch plunger face the inner door panel. You could also consider a new latch assembly W10275768 which has the switches pre mounted and aligned.
All the buttons on the control panel of my dishwasher work but the machine will not start any ideas?
Answer Hello Dustin. Check and see if the door switches 99002751 are bad on the unit. If not, then the control panel 6-919821 is bad and will need to be replaced on the unit. Hope this helps.
We were remodeling our kitchen, and when we were reinstalling the dishwasher, it turned on once and after that the panel does not even light up. We chacked all power and it is fine.
Answer Hello Terry. First check and make sure the door latch W10130695 is good and is latching properly. If it is bad, there will be no power at the board. You will need to test and see if your getting power to the control board. If there is power there, you will need to remove the ribbon cable for the control panel and make sure it is clean and dry. If it is good, you may have a bad control board. We will need your serial number to find the correct control board for your model. Hope this helps.