Washer continues to fill up and never starts agitating. Switched out the Dog Agits and still doing the same thing. It will do all the other functions i.e. drain, spin, fill but will not agitate.
Answer Facto, First check and make sure the drain hose and standpipe are at the correct height off the floor (38 to 39 inches) the washer will "syphon" if the drain hose is too low. If that's alright, then you'll need to check or replace the control board 8577278 and check the wires between the motor and control board for loose or broken connections.
How should the lid lever be positioned relative to the lid switch lever? Thanks.
When the lid lever is installed it will go through the main top and the lid side will line up and screw into the lid. This will position the lid lever properly to hit the switch.
My washer runs, fills, and agitates but will not spin.
Answer Hello Toni. It sounds like the lid switch 8054980 may be bad and need to be replaced on the unit.
Have code 35,,, Changed out the Pressure Switch (W10415587)ran self diagnostics test, unit would not respond to test. Help
Answer Hello Devon. The F35 code does mean a problem with the pressure switch. It is either a problem with the switch itself or the control board not reading it properly. Make sure the hose is attached properly, and not clogged, and the air trap is not clogged. If everything is clear and the new switch did not fix the problem then the board part# [W10180782] will need to be replaced.
Where is the switch-lid locate on kenmore washer machine model 11022972100
Answer Hello Bayardo. You will have to remove the two screws that hold down the control panel and pivot it up out of the way. Then you should see the tabs from the switch either on the left or right side. You will have to remove the cabinet to access the lid switch. Thanks!
Wash will only go to spin cycle part of the time.
Answer Hello Fred. You will need to check and see if the lid switch 8054980 is bad on the unit or if the lid switch strike on the lid id loose or bad. If so, it will cause the issues you are having.