I have Whirlpool Duet washer that is showing Error codes F35 and F27. I dont know what part I need change.
Answer Hello Selam,
Error Code F27 indicates an overflow condition in which there is too much water or foam in the machine. Overflow contact on the pressure switch is closed. Check the drain for clogs and that it is not kinked Also check the pump for obstructions or clogs. F35 error code indicated analog pressure switch W10415587 failure. Ensure pressure hose is affixed properly, that the air trap is not blocked and that the hose is not blocked. If all this checks ok you will need to replace analog pressure switch.
Sud shows then F35 error code when Whirlpool washer is turned on. Can you tell me what part looks like that I need?
Answer Hello Jimmy,
F35 error code on some models indicate that the analog pressure switch is bad. Check your hoses to the pressure switch to ensure good connection, that hose is not restricted and air trap is not restricted. With the model number we would be able to provide more information on you unit.
Our washing machine was also displaying the f35 error code. We cleaned out the hoses and just purchased the new pressure switch from you, replaced it and it is still displaying the f35 error code! Help!!!!
Answer Hello Shannon. Blow through the hose and make sure all is clear. Also, remove the large hose from the tub and make sure nothing is in the large hose. If all is clear, and you still get the code, and the pressure switch is new, replace the main control board.
I too have the code F35 that comes up. You talk about cleaning out the pressure tube but you don't say where it is or how to get to it. Where is it? Thanks, Ernesto
Answer Ernesto, The air tube is the hose W10004260 that attaches to the water level switch W10415587. Disconnect the hose from the switch and blow in the end of the hose, there should be little or no resistance. You may also want to remove the lower access panel, and remove and check the drain pump filter and interior for debris and build ups inside the pump. Thanks
I ordered pressure switch AP5264563. I removed the old switch but having trouble inserting the electric wire into new pressure switch. Help.
Answer Hello Eddie. Make sure you line the ridges on the plug up with the groves on the switch W10415587. Then you will press the plug onto the switch. It will only fit one way. Hope this helps.