At the end of my washers cycle it adds water after the rinse.
Answer Hello Ben. You will need to replace the water level switch and the timer to repair the unit if it is an auto load level unit.
Washer quits mid rinse cycle. Have replaced timer and intake valve already, still quits mid rinse cycle. Checked lid switch and it clicks and such when lid is closed. Can move timer to other cycles and it works, but when it comes to a rinse cycle, fills briefly, then quits.
Answer Chad, You're on target, thinking the water temperature switch is at fault. The printed circuit board inside the switch W10293048 usually develops a weak circuit, and the washer has several possible fill issues, including no cold fill. replace the switch W10293048 and you should be fine. (you have the incorrect part number for the model number you supplied).
Timer went out. I put a new on. The timer works now, but no water. All wires connected.
Answer Hello Jim. Based on the information you provided, it sounds like the temperature switch W10248240 is bad and will need to be replaced on the unit.
Machine keeps filling during agitate cycle and overflows, water/temp sensor switch?
Answer Hello Dawgdays. If you can stop the water from entering the machine by turning off the timer or unplugging the unit, you will need to look for a bad pressure hose or replace the pressure switch. If the only way to shut off the water is at the shut off for the water hoses, you will need to replace the water valve in the unit.
The washer first wound up not letting water in. Turned Off Hot water, now it will not fill on the rinse cycle, we have to lift the lid to make it fill. I was told it might be the temp. control switch.
Answer Linda, Yes it is most likely the water temperature switch W10248240 with your description it would be the place to start. This particular switch controls the water temperature, the water level, and the timer delay for certain cycles, all through a printed circuit board inside the switch. all your issues would be associated with the switch. You also want to check the wiring harness/connector that attaches to the electronic control W10104800 mounted on the back of the timer. Make sure it is pressed and locked in place on the control connector.