Stove top burners won't turn off. This is an electrical whirlpool
Answer Richard, You'll need to circuit check the burner infinite switches and wires, to the affected elements. If the switch circuits are not "opening" when the switch is in the "OFF" position, the elements will remain on and hot. A model number would be a great assist in helping you. Thanks
I was cleaning the element cartridge and when i plugged it back in it sparked. Do I need to replace the element receptacle?, Receptacle, or the whole unit? I turned it back on later and it worked and then when turned on another time it sparked
Answer Mom, If the arcing was at the cooking bay (where the receptacle plugs in) you will want to check and replace the wiring kit to the receptacle 702042K. It's the only kit available at this time. But make sure the receptacle pins and area are completely dry. Good Luck and Thanks
Replaced receptacles. All burners on, but light still on and oven cleaner will not work displaying?
Answer Hello Charles. Based on the information you provided, it sounds like the control board is bad. You will need to test for power coming to the control board. If there is power there, and the display does not work, replace the control board. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html
Would these receptacle work on my whirlpool stove?
Answer Charles, the receptacle kit is part number 330031. Thanks!
Will this kit fit whirlpool electrical range model RF263LXTQ3? Thanks a lot.
Answer Hello Jessica. Yes, the receptacle kit 330031 will work on the model number you provided. Hope this helps.
For my Whirlpool Model RS630PXK I'd like to replace all of the top burner receptacles along with the (somewhat scorched looking) wires going from the receptacles to the controls. I have not been able to locate the required heat insulated wire. Do you sell it? If not, do you know where I can get it? Thank you for your help.
Answer Hi Elliot. The burner receptacle kit is for one burner as you need to order 4-total. As for the wire it is a 105° rated wire the industry has used now for a number of years. It is extremely hard to find. A better complete wire harness kit that is pre wired to ceramic receptacles (better than plastic) is part # 3190716 . And you will need to purchase ceramic wire nuts to help secure wires to the harness is part # TJMA01165-1. Good luck and Thank You.