24/7 Customer Support

CHECKOUT
Items in Cart:
Total
$0.00

Customer Questions and Answers for Water Valve by Whirlpool

  1. Our Price $42.66
    Compare At $59.97
    You Save $17.31
     
    • Part Number: AP4456759
    • MFG Part Number: 6-920534
    • Made by: Whirlpool
    Add to Cart

Questions & Answers

For Whirlpool Water Valve (Part Number: AP4456759)

Ask a Question

Most Interesting  |  Latest Questions

Hello... It seems like my dishwasher is NOT filling up with enough water, therefore when it runs it make a loud humming noise, and I don't hear the water splashing around like it use too, but when I open the door It looks wet but not enough to melt the soap either. Thanks in Advance for your help...

Ron for Model Number MDBTT59AWW

Answer

Was this helpful?

1 Answer

The dishwasher in our new house leaks through a faulty door gasket/seal - this was found during the home inspection. When I began to troubleshoot the issue, I noticed that the tub fills with (and doesn't drain) water without the dishwasher having been run. When I drain the tub (the drain function on the dishwasher works when you hold down that button) and shut off the water supply, the problem doesn't resurface. When I turn the supply valve back on to hand-wash some dishes in the sink, the tub begins to fill again at a very slow rate - the over-spill might start to happen after 24 hours or so of having hot water pressure. I disconnected the power to the unit at the circuit breaker and tested the resistance of the water inlet valve. This reading was right at 1,000 ohms, which I understand is right in the middle of the working electrical specification. I have to assume at this point that the valve is slightly stuck in the open position, or that there's a faulty gasket or o-ring in that part. Along with ordering a new door gasket, I am looking for validation that Whirlpool part 6-920534 is my most likely point of failure in relation to this problem. Many thanks, Joe

Joe B for Model Number Jenn-Air JDB2150AWP

Answer

Was this helpful?

1 Answer

Hi: We had frozen pipes over the weekend and forgot to drain the dishwasher prior to leaving. Yesterday, when we got all the water working, we started the dishwasher and water started running out the door. This happened several years ago and we replaced the water inlet valve. Does this sound like the same issue? I just ordered the part and hope I made the right diagnosis...

Shannon for Model Number MDBH945AWB

Answer

Was this helpful?

1 Answer

When I turn on water to dishwasher water does not stop coming in.

Gary for Model Number mdb6600aww

Answer

Was this helpful?

1 Answer

During some unrelated plumbing work in the house, I ended up with sediment throughout the system including at every faucet & appliance. I cannot seem to be able to locate the sediment filter on my dishwasher, (Maytag Quiet Series 100 MDB5600AWW).

Phil for Model Number MDB5600AWW

Answer

Was this helpful?

1 Answer

I am only getting 75 VAC at the Water inlet Valve. It should be 120 VAC. I have replaced the control board. Then a new water inlet valve. What else could cause this?

Kenneth for Model Number MDBH955AWB

Answer

Was this helpful?

1 Answer

Will a bad fill valve shut off the water if the pressure in the feed line is high? I have to turn my water feed line to very low pressure to fill the washer. If the line feed is opened to normal flow the washer will not fill. The plummer contractor during a recent visit noted that the water pressure is normal in that line.

Kenneth for Model Number MDBH955AWB

Answer

Was this helpful?

1 Answer

Maytag diswasher is not cleaning the dishes. I just chaged the water intake valve, cleaned the filter, Check for leak etc.. But there is no luck. Still it is not cleaning.. Any other suggestion?? Thanks

Gokhan for Model Number Maytag - mdbtt79aww

Answer

Was this helpful?

1 Answer

My brand new dishwasher won't drain all the way the pump does not seem to pump the water very fast I checked the hose for kinks I blew into the drain hose and air came out in the dishwasher.

Bill for Model Number mdb7749aww1

Answer

Was this helpful?

1 Answer

My washer was filling only partially. Replaced this part ~18 months ago and it fixed the problem, now it's back. Any suggestions?

A

Answer

Was this helpful?

1 Answer

 

 
 
We are Safe, Secure, Dependable and Trusted
  • BizRate.com Customer Certified Site - Click to Verify