My glow stick glows but oven wont get hot.
Answer Hello Tony. Test for 3.2-3.6 ampson the igniter oven bake turned on. If the amperage is there, you have a bad safety valve. If the amperage is low, you have a weak igniter and the igniter will need to be replaced. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html
I set the oven for 350°F. The display says its 350°F, but it's only 200°F.
Answer Hello Robert,
Sounds like the temperature sensor 12001655 has failed. Check the connections to it first and if you have a test meter, the temperature sensor should read about 1100 ohms at 70°F. Be aware that when you are testing the temperature sensor you should tap on it while testing to get it to show a problem if it's intermittent.
The oven comes on and heats fine but will not shut off unless you unplug the power to the stove. Thanks Dean
Answer Hello Dean. Based on the information you provided, it sounds like the electronic control 12001613 is bad and will need to be replaced on the unit. This part has been permanently discontinued by the manufacturer and we don't know of any source or replacement for the part. Thanks.
Magic Chef oven does not light, the igniter is glowing, but burner does not come on, the broiler and top gas works fine, what could it be?
Answer Hello John. Test for 3.2-3.6 volts AC at the gas safety valve with the igniter turned on. If the voltage is there, you have a bad safety valve 74006427. If the voltage is low, you have a weak igniter and the igniter will need to be replaced. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html