When I ordered the water tube #2255153 it didn't have a flaired in on the water tube. I have a quick disconnect on my Kenmore model 106.58962702, When I put the tube in it just easily popped out.
You will want to make sure that the water tube is pushed in all the way. Sometimes the tubing will stop like it is fully seated but will not be. Push in a little further and if it still is coming out when pulled on then replace the housing.
Tube which connects water line to Filter inline broke during transportation. Need to know the part - order it and how to replace instructions.
Diagram will be great.
Answer Hello Naveed,
The Filter inlet tube part number is 2255153. To replace you will remove lower kickplate, take the 2 5/16" screws out from filter housing. Pull filter housing out and disconnect water line. Install new line and reinstall filter housing. Connect to water supply.
How do I change the water resovoi tube?
Answer Hello John,
To replace the reservoir tube you will need to remove the 2 lower crispers in the refrigerator. Pull unit out and turn off water supply. Pull lower cover off the back of the unit and the toe grill off the front of unit. Disconnect the connector to the water line to freezer door. Remove the water valve and disconnect the 5/16" water line that goes to the water tank. To disconnect it may have a push connector. Push in on the ring around the tubing and pull out on tubing at the same time. Once water lines are disconnected you would pull old tank out and install new. When pushing tubing down through the floor. the longer line will go to the freezer door. Reassemble in reverse.
How do I change the tubing from the resovoir through the door.
Answer Hello John,
In order to change the tubing through the door you will need to remove the dispenser section parts. You will use a flat blade screw driver under the bottom front of dispenser trim and pry loose. Once you have this done you willl have to remove the dispenser bracket and levers. At the bottom of door remove the coupler on the freezer side of the door. Once this removed you can pull water line out. You may want to tape new water line to the old and pull out from hinge or you could pull up from dispenser side. Once through you can reconnect lines. The water line that goes back under unit to the water tank is part of the water tank and tank would have to be replaced to replace this line.
I need the water tube for inside the door, which one do I need and how do I install it?
Answer John, the water tube inside the door is part number 8201537. Here is the link to our repair forum for free installation assistance. Thanks! http://forum.appliancepartspros.com/