24/7 Customer Support

CHECKOUT
Items in Cart:
Total
$0.00

Customer Questions and Answers for Water Valve (3 Way) by Whirlpool

  1. Our Price $61.25
    Compare At $74.38
    You Save $13.13
     
    • Part Number: AP4044218
    • MFG Part Number: 34001248
    • Made by: Whirlpool
    Add to Cart

Questions & Answers

For Whirlpool Water Valve (3 Way) (Part Number: AP4044218)

Ask a Question

Most Interesting  |  Latest Questions

Where is this part located on the washer? Is replacement difficult?

O.m. Young for Model Number 34001248

Answer

1 person found this answer helpful.

Was this helpful?

1 Answer

Before I replace the 3 way valve, here is what I observed. The softener product when poured into its cup would remain after the wash cycle was completed all other cups (bleach etc) received water. Am I on the right track?

Warryn for Model Number MAH9700AWW

Answer

Was this helpful?

1 Answer

How to install this part ap40442?

Jake for Model Number mah8700aww

Answer

Was this helpful?

1 Answer

My machine works well with just cold water. The hot water does not shut off. It continues to run. I can turn it off after a few minutes and it will continue the wash.

Nancy for Model Number MAH8700AWW

Answer

Was this helpful?

1 Answer

We are getting the error code "nF" which means there is a water fill problem. Which part do I replace? Washer works with cold water only, but not with hot. I checked both hoses and they are fine.

Sprtndad for Model Number MAH9700AWW

Answer

Was this helpful?

1 Answer

The bleach valve on our washer seems to be getting stuck in the open position. Start the wash cycle and it works just fine, but when washer goes into rinse and spin modes, the bleach valve constantly adds water. If I turn the cold water valve off and then on again it stops. I ran all of the "Service Mode" diagnostics and the bleach valve passed the "Quick Service Cycle. In the "Board Output Test", the bleach valve sticks in the open position when I set selector to "delicates". Opens fine when I push selector knob, but will not close when I press a second time. Just wondering if the problem is the valve assembly or the electronics since it passed one test and failed the other.

Don for Model Number Maytag MAH8700A

Answer

Was this helpful?

1 Answer

Washer will not dispense hot or cold water. When this started I was getting severe vibration in water line.

Jb for Model Number MAH8700AWW

Answer

Was this helpful?

1 Answer

My washer runs water continuously, even unplugged. I know its not supposed to, my question is does the three way water valve act as a check valve, stopping the water there and distributing it as it needs it?

Pam for Model Number MAH8700AWW

Answer

Was this helpful?

1 Answer

What does the 3-way water inlet valve do? My washer will start the wash cycle, the water will run, and the machine will begin the wash cycle. About 5 minutes into the cycle the machine will display an OE error. I have replaced the water level sensor, but still get the error. Before replacing the water level sensor, the error would display immediately. With the new sensor, the wash cycle runs a little longer before displaying the error code.

Joe R. for Model Number MAH9700AWW

Answer

Was this helpful?

1 Answer

Is it OK to order the part, install it to first see if that truly does take care of the problem and then release the money to you? I'm not trying to "hold you up" I just don't want to pay for anything that doesn't work.

Guest

Answer

Was this helpful?

1 Answer

 
We are Safe, Secure, Dependable and Trusted
  • BizRate.com Customer Certified Site - Click to Verify